SN EN 50132-4-1 : 2001

Introduction
1 Scope
2 Normative references
3 Definitions and abbreviations
  3.1 Definitions
  3.2 Abbreviations
4 Requirements
  4.1 General
  4.2 Scanning standard and synchronization
  4.3 Visible diagonal of the display device
  4.4 Input impedance
  4.5 Input signal level and polarity
  4.6 Interlace factor
  4.7 Frequency response
  4.8 Horizontal resolution
  4.9 Modulation transfer function
  4.10 Geometric distortion
  4.11 Picture size stability
  4.12 Black level stability
  4.13 Grey scale
  4.14 Interference and positional hum
  4.15 Power supply
  4.16 Electrical safety
  4.17 X-ray radiation
  4.18 Electro-magnetic compatibility (emission)
  4.19 Electro-magnetic compatibility (immunity)
  4.20 Environmental conditions
5 Test conditions
  5.1 General
  5.2 Test equipment
  5.3 Test conditions
6 Performance tests
  6.1 Input signal level test
  6.2 Polarity of the input signal test
  6.3 Video input termination
  6.4 Synchronization
  6.5 Picture size stability
  6.6 Black level stability
  6.7 Grey scale
  6.8 Frequency response
  6.9 Interlace factor
  6.10 Geometric distortion
  6.11 Horizontal resolution
  6.12 Modulation transfer function
  6.13 Positional hum
  6.14 Mutual interference
7 Environmental testing
  7.1 Introduction
  7.2 Selection of tests and severities
  7.3 Dry heat (operational)
  7.4 Dry heat (endurance)
  7.5 Cold (operational)
  7.6 Damp heat, steady state (operational)
  7.7 Damp heat, steady state (endurance)
  7.8 Damp heat, cyclic (operational)
  7.9 Damp heat, cyclic (endurance)
  7.10 Water (endurance)
  7.11 Sulphur dioxide (SO[2]) corrosion (endurance)
  7.12 Salt mist, cyclic (endurance)
  7.13 Shock (operational)
  7.14 Vibration, sinusoidal (operational)
  7.15 Vibration, sinusoidal (endurance)
  7.16 Dust tightness (endurance)
8 Documentation
9 Marking and labelling
Annex A Test patterns (normative)
  A.1 Window signal
  A.2 Cross hatch signal
  A.3 Linearity test pattern
  A.4 Grey scale signal
  A.5 Frequency burst signal
  A.6 Checker board signal

Specifies the minimum requirements for the specification and testing of black and white video monitors used in 625-line CCIR standard closed circuit television (CCTV) surveillance systems for security applications.