SN EN 60317-0-2 : 1998 AMD 1 2000
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
SPECIFICATIONS FOR PARTICULAR TYPES OF WINDING WIRES - PART 0: GENERAL REQUIREMENTS - SECTION 2: ENAMELLED RECTANGULAR COPPER WIRE
11-11-2016
12-01-2013
Foreword
Introduction
1 Scope
2 Normative references
3 Definitions, general notes on test on appearance
4 Dimensions
5 Electrical resistance
6 Elongation
7 Springiness
8 Flexibility and adherence
9 Heat shock
10 Cut-through
11 Resistance to abrasion
12 Resistance to solvents
13 Breakdown voltage
14 Continuity of insulation
15 Temperature index
16 Resistance to refrigerants
17 Solderability
18 Heat or solvent bonding
19 Dielectric dissipation factor
20 Resistance to transformer oil
21 Loss of mass
23 Pin-hole test
30 Packaging
Annex A (informative) Nominal cross-sectional areas
for preferred and intermediate sizes
Annex B (informative) Special tolerances
Annex E (informative) High temperature failure test
Annex ZA (normative) Normative references to international
publications with their corresponding
European publications
Defines the general requirements of enamelled rectangular copper winding wires.
| DocumentType |
Standard
|
| PublisherName |
Swiss Standards
|
| Status |
Superseded
|
| SupersededBy |
| Standards | Relationship |
| DIN EN 60317-0-2:2014-10 | Identical |
| EN 60317-0-2:2014 | Identical |
| IEC 60317-0-2:2013 | Identical |
| BS EN 60317-0-2:2014 | Identical |
| I.S. EN 60317-0-2:2014 | Identical |
| UNE-EN 60317-0-2:1998 | Identical |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.