SN EN 60835-3-10 : 1994

Committees responsible
National foreword
Foreword
Introduction
1. Scope
2. Normative references
3. I.F. interface characteristics
3.1 Return loss
3.2 Level, frequency and spectrum of the modulator
      output signal
3.3 Carrier on-off ratio
3.4 Phase and amplitude balance
4. Terrestrial interface characteristics
4.1 Level and shape of the output signal
4.2 Other parameters
5. Bit error ratio
5.1 General considerations
5.2 Modem BER performance
5.3 Overall system BER performance
6. Frame acquisition and synchronization
6.1 General considerations
6.2 Clock frequency and acquisition time
6.3 Receive frame acquisition and synchronization
6.4 Transmit frame acquisition
6.5 Transmit frame synchronization
6.6 Synchronization characteristics with additive noise
7. System control functions
7.1 General considerations
7.2 Reference station changeover test
7.3 Burst Time Plan and/or Channel Mapping Plan change
      test
7.4 Other monitor and control function tests, including
      service channels
Figures
1. Typical TDMA terminal equipment used in a traffic
      earth station
2. Typical arrangement for modem BER measurement
3. Typical arrangement for overall system BER test
4. Typical arrangement for frame acquisition/
      synchronization test
Annex ZA (normative) Other international publications
quoted in this standard with the reference of the
relevant European publications

ALSO NUMBERED AS BS 7573 SECTION 3.10 1995 Deals with methods of measurement on Time Division Multiple Access (TDMA) terminal equipment.