• Shopping Cart
    There are no items in your cart

SN EN 60927 : 1996 AMD 1 1999

Superseded

Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

AUXILIARIES FOR LAMPS - STARTING DEVICES (OTHER THAN GLOW STARTERS) - PERFORMANCE REQUIREMENTS

Superseded date

30-10-2021

Published date

12-01-2013

Sorry this product is not available in your region.

Committees responsible
National foreword
Foreword
Section one - General requirements
1 Scope
2 Definitions
3 General requirements for tests
4 Marking
Section two - Performance requirements for starters
                (other than glow starters) for
                fluorescent lamps
5 Scope
6 Starting test
7 Endurance test
8 Deactivated lamp test
Section three - Performance requirements for ignitors
9 Scope
10 Starting test
11 Non-reoperating level
12 Endurance test
Annexes
A (normative) Ballasts to be used for life testing
B (informative) Explanation of starting conditions
    for electronic starters with an electronic
    switching element
C (informative) A guide to quoting product life and
    failure rate
ZA (normative) Normative references to international
    publications with their corresponding European
    publications
Figure 1 - Pulse voltage measurement for starting devices
Figure 2 - Ignition energy measurement for non-triggered
           starting devices
Figure B.1 - Cathode heating current requirements for
           electronic starters with electronics
           switching element
Figure B.2 - Interpretation of effective heating current
Figure B.3.1 - Starters which remove pre-heating current
           when open-circuit voltages are elevated
Figure B.3.2 - Starters which have open-circuit voltage
           transition times higher than 100 ms
Table 1 - Starting aid requirements

Describes performance requirements for starting devices (starters and ignitors) for tubular fluorescent and other discharge lamps for use on a.c. supplies up to 1,000V at 50 Hz to 60 Hz, which produce starting pulses not greater than 5 kV.

DocumentType
Standard
PublisherName
Swiss Standards
Status
Superseded

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.