SN EN 792-1 : 2000 + A1 2008

Foreword
0 Introduction
1 Scope
2 Normative references
3 Terms and definitions
      3.1 General terms and definitions
      3.2 Terms and definitions related to assembly power
             tools for non-threaded mechanical fasteners
4 List of hazard
5 Safety requirements and measures
      5.1 Mechanical safety
      5.2 Thermal safety
      5.3 Noise
      5.4 Vibration
      5.5 Materials and substances processed, used or
             exhausted
      5.6 Ergonomics
      5.7 Safety related measures and means
6 Information for use
      6.1 Marking, signs and written warnings
      6.2 Instructions for use
7 Verification
      7.1 Noise
      7.2 Vibration
      7.3 Unintentional start
      7.4 Structure of verification
Annex A (informative) Examples of assembly power tools for
                      non-threaded mechanical fasteners
                      covered by this part
Annex B (informative) Symbols for labels and signs
Annex ZA (informative) Clauses of this European Standard
                       addressing essential requirements or
                       other provisions of EU Directives
Bibliography

Applicable to hand-held non-electric power tools driven by linear or rotary motors, powered by compressed air, hydraulic fluid and intended to be used by one operator and supported by the operator's hand or hands; harness, or a suspension,e.g a balancer. Applicable to hand-held non electric power tools for the installation, tightening or removal of both break stem and non-break stem rivets, plugs, bolts and fasteners from one side of a workpiece into metals, plastics and other materials. Covers: breakstem fastener, rivet or plug tools; breakstem lockbolt tools; rivet nut setter and mandrel loaded riveting tools.