SN EN ISO 10405:2007

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Running and pulling casing
  4.1 Preparation and inspection before running
  4.2 Drifting of casing
  4.3 Stabbing, making up and lowering
  4.4 Field makeup
  4.5 Casing landing procedure
  4.6 Care of casing in hole
  4.7 Recovery of casing
  4.8 Causes of casing trouble
5 Running and pulling tubing
  5.1 Preparation and inspection before running
  5.2 Stabbing, making up and lowering
  5.3 Field makeup
  5.4 Pulling tubing
  5.5 Causes of tubing trouble
6 Transportation, handling and storage
  6.1 Transportation
  6.2 Handling
  6.3 Storage
7 Inspection and classification of used casing and tubing
  7.1 General
  7.2 Inspection and classification procedures
  7.3 Pipe wall and threaded-joint conditions
  7.4 Service rating
8 Reconditioning
9 Field welding of attachments on casing
  9.1 General
  9.2 Requirements for welds
  9.3 Processes
  9.4 Filler for arc welding
  9.5 Preparation of base metal
  9.6 Preheating and cooling
  9.7 Welding technique
Annex A (informative) - SI units

Lays out practices for care and use of casing and tubing.