UNE-EN IEC 61000-6-8:2020

This generic EMC emission standard is applicable only if no relevant dedicated product orproduct family EMC emission standard has been published.This part of IEC 61000 for emission requirements applies to electrical and electronicequipment intended for use in commercial and light-industrial (see 3.1.3) locations. This partapplies to equipment that satisfy the following restrictions of use:" is defined as professional equipment (see 3.1.13)," requires professional installation and maintenance (see 3.1.14 and Clause 6)," is not intended to be used in residential locations (see 3.1.16).IEC 61000-6-3 applies to electrical and electronic equipment intended for use at commercialand light-industrial locations that do not satisfy these restrictions.The intention is that all equipment used in the residential, commercial and light-industrialenvironments shall be covered by IEC 61000-6-3 or IEC 61000-6-8. If there is any doubt therequirements in IEC 61000-6-3 shall be applied.Emission requirements within the frequency range 0 Hz to 400 GHz are covered.The conducted and radiated emission requirements in the frequency range up to 400 GHz areconsidered essential and have been selected to provide an adequate level of protection ofradio reception in the defined electromagnetic environment. Not all disturbance phenomenahave been included for testing purposes but only those considered relevant for the equipmentintended to operate within the locations included within this standard. No measurement needsto be performed at frequencies where no requirement is specified.The emission requirements in this standard are not intended to be applicable to the intentionaltransmissions and their harmonics from a radio transmitter as defined by the ITU.NOTE 1 Safety considerations are not covered by this standard.NOTE 2 In special cases, situations will arise where the levels specified in this standard will not offer adequateprotection; for example where a sensitive receiver is used in close proximity to an equipment. In these instances,employ special mitigation measures to reduce any impact.NOTE 3 Disturbances generated in fault conditions of equipment are not covered by this standard.NOTE 4 Equipment which complies with IEC 61000-6-3 are suitable for use within these defined locations.