UNI EN ISO 15530-3 : 2011

Current

Current The latest, up-to-date edition.

GEOMETRICAL PRODUCT SPECIFICATIONS (GPS) - COORDINATE MEASURING MACHINES (CMM): TECHNIQUE FOR DETERMINING THE UNCERTAINTY OF MEASUREMENT - PART 3: USE OF CALIBRATED WORKPIECES OR MEASUREMENT STANDARDS

Available format(s):

Language(s):

Published date: 12-12-2011

Publisher: Ente Nazionale Italiano di Unificazione (UNI)

Table of Contents - (Show below) - (Hide below)

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols
5 Requirements
6 Principle of the uncertainty evaluation using calibrated
workpieces
7 Procedure
8 Reverification of the measurement uncertainty
9 Interim check of the measurement uncertainty
Annex A (informative) - Examples of application
Annex B (informative) - Relation to the GPS matrix model
Bibliography

Abstract - (Show below) - (Hide below)

Describes the evaluation of measurement uncertainty for results of measurements obtained by a CMM (coordinate measuring machine) and by using calibrated workpieces or measurement standards.

General Product Information - (Show below) - (Hide below)

Committee	CT 47
Development Note	Supersedes UNI CEN ISO/TS 15530-3. (12/2011)
Document Type	Standard
ISBN
Pages
Published
Publisher	Ente Nazionale Italiano di Unificazione (UNI)
Status	Current
Supersedes	UNI CEN ISO/TS 15530-3 : 2008

International Equivalents – Equivalent Standard(s) & Relationship - (Show below) - (Hide below)

Equivalent Standard(s)	Relationship
ISO 15530-3:2011	Identical
EN ISO 15530-3:2011	Identical

Standards Referencing This Book - (Show below) - (Hide below)

ISO/TR 14638:1995	Geometrical product specification (GPS) Masterplan
ISO 8015:2011	Geometrical product specifications (GPS) Fundamentals Concepts, principles and rules
ISO 10360-1:2000	Geometrical Product Specifications (GPS) — Acceptance and reverification tests for coordinate measuring machines (CMM) — Part 1: Vocabulary
ISO 14978:2006	Geometrical product specifications (GPS) General concepts and requirements for GPS measuring equipment
ISO 14253-1:2017	Geometrical product specifications (GPS) — Inspection by measurement of workpieces and measuring equipment — Part 1: Decision rules for verifying conformity or nonconformity with specifications
ISO/IEC Guide 99:2007	International vocabulary of metrology Basic and general concepts and associated terms (VIM)
ISO/IEC Guide 98-3:2008	Uncertainty of measurement — Part 3: Guide to the expression of uncertainty in measurement (GUM:1995)

Categories associated with this Standard - (Show below) - (Hide below)

Sub-Categories associated with this Standard - (Show below) - (Hide below)

Sorry this product is not available in your region.

Add To Cart