UNI ISO 13041-2 : 2010
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
TEST CONDITIONS FOR NUMERICALLY CONTROLLED TURNING MACHINES AND TURNING CENTRES - PART 2: GEOMETRIC TESTS FOR MACHINES WITH A VERTICAL WORKHOLDING SPINDLE
17-09-2022
01-01-2010
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Preliminary remarks
5 Geometric tests
6 Tests for checking the accuracy of axes of rotation
Annex A (informative) - Three point method
Bibliography
Describes the geometric tests on general purpose numerically controlled (NC) turning machines and tuning centres with vertical workholding spindles, as well as the corresponding applicable tolerances.
| DocumentType |
Standard
|
| PublisherName |
Ente Nazionale Italiano di Unificazione (UNI)
|
| Status |
Superseded
|
| SupersededBy |
| Standards | Relationship |
| ISO 13041-2:2008 | Identical |
| ISO 230-7:2015 | Test code for machine tools Part 7: Geometric accuracy of axes of rotation |
| ISO 3442-3:2007 | Machine tools Dimensions and geometric tests for self-centring chucks with two-piece jaws Part 3: Power-operated chucks with serrated jaws |
| ISO 841:2001 | Industrial automation systems and integration — Numerical control of machines — Coordinate system and motion nomenclature |
| ISO 13041-3:2009 | Test conditions for numerically controlled turning machines and turning centres Part 3: Geometric tests for machines with inverted vertical workholding spindles |
| ISO 230-1:2012 | Test code for machine tools — Part 1: Geometric accuracy of machines operating under no-load or quasi-static conditions |
| ISO 3442-1:2005 | Machine tools — Dimensions and geometric tests for self-centring chucks with two-piece jaws — Part 1: Manually operated chucks with tongue and groove type jaws |
| ISO 2806:1994 | Industrial automation systems — Numerical control of machines — Vocabulary |
| ISO 13041-1:2004 | Test conditions for numerically controlled turning machines and turning centres Part 1: Geometric tests for machines with a horizontal workholding spindle |
| ISO 6155:1998 | Machine tools Test conditions for horizontal spindle turret and single spindle automatic lathes Testing of the accuracy |
| ISO 1708:1989 | Acceptance conditions for general purpose parallel lathes Testing of the accuracy |
| ISO 3442-2:2005 | Machine tools — Dimensions and geometric tests for self-centring chucks with two-piece jaws — Part 2: Power-operated chucks with tongue and groove type jaws |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.