ISO 8521:2009
|
Plastics piping systems Glass-reinforced thermosetting plastics (GRP) pipes Test methods for the determination of the apparent initial circumferential tensile strength |
ISO 7511:1999
|
Plastics piping systems — Glass-reinforced thermosetting plastics (GRP) pipes and fittings — Test methods to prove the leaktightness of the wall under short-term internal pressure |
EN 681-1:1996/A3:2005
|
ELASTOMERIC SEALS - MATERIALS REQUIREMENTS FOR PIPE JOINT SEALS USED IN WATER AND DRAINAGE APPLICATIONS - PART 1: VULCANIZED RUBBER |
ISO 527-4:1997
|
Plastics Determination of tensile properties Part 4: Test conditions for isotropic and orthotropic fibre-reinforced plastic composites |
ISO 7685:1998
|
Plastics piping systems Glass-reinforced thermosetting plastics (GRP) pipes Determination of initial specific ring stiffness |
ISO/TR 10465-2:2007
|
Underground installation of flexible glass-reinforced pipes based on unsaturated polyester resin (GRP-UP) Part 2: Comparison of static calculation methods |
ISO/TR 10465-3:2007
|
Underground installation of flexible glass-reinforced pipes based on unsaturated polyester resin (GRP-UP) Part 3: Installation parameters and application limits |
ISO 10928:2016
|
Plastics piping systems — Glass-reinforced thermosetting plastics (GRP) pipes and fittings — Methods for regression analysis and their use |
ISO 161-1:1996
|
Thermoplastics pipes for the conveyance of fluids Nominal outside diameters and nominal pressures Part 1: Metric series |
ISO 8639:2016
|
Glass-reinforced thermosetting plastics (GRP) pipes and fittings — Test methods for leaktightness and proof of structural design of flexible joints |
ISO 75-2:2013
|
Plastics — Determination of temperature of deflection under load — Part 2: Plastics and ebonite |
ISO 527-5:2009
|
Plastics Determination of tensile properties Part 5: Test conditions for unidirectional fibre-reinforced plastic composites |
ISO 3126:2005
|
Plastics piping systems Plastics components Determination of dimensions |
ISO 11922-1:1997
|
Thermoplastics pipes for the conveyance of fluids — Dimensions and tolerances — Part 1: Metric series |
ISO/TR 10465-1:1993
|
Underground installation of flexible glass-reinforced thermosetting resin (GRP) pipes Part 1: Installation procedures |
ISO 2078:1993
|
Textile glass Yarns Designation |
ISO 8513:2016
|
Plastics piping systems — Glass-reinforced thermosetting plastics (GRP) pipes — Test methods for the determination of the initial longitudinal tensile strength |
ISO 4200:1991
|
Plain end steel tubes, welded and seamless — General tables of dimensions and masses per unit length |
ISO 10466:1997
|
Plastics piping systems Glass-reinforced thermosetting plastics (GRP) pipes Test method to prove the resistance to initial ring deflection |
ISO 2531:2009
|
Ductile iron pipes, fittings, accessories and their joints for water applications |
ISO 7509:2015
|
Plastics piping systems Glass-reinforced thermosetting plastics (GRP) pipes Determination of time to failure under sustained internal pressure |