12/30265053 DC : 0
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
BS ISO 19072-2 - ROAD VEHICLES - CONNECTION INTERFACE FOR PYROTECHNIC DEVICES, TWO-WAY AND THREE-WAY CONNECTIONS - PART 2: TEST METHODS AND GENERAL PERFORMANCE REQUIREMENTS
Hardcopy , PDF
30-09-2013
English
Important note : Users cannot be edited or removed once added to your Multi user PDF.
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Functional characteristics of mated connectors
5 Test sequences
Annex A (normative) - Sealed variant of the pyrotechnic
device/initiator harness connector assembly
Annex B (normative) - Two way (without ground) variant
of the pyrotechnic device/initiator harness
connector assembly
Annex C (normative) - Variant without retainer of
the pyrotechnic device/initiator harness
connector assembly
Bibliography
BS ISO 19072-2.
| Committee |
AUE/16
|
| DocumentType |
Draft
|
| Pages |
27
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy |
| ISO 16750-2:2012 | Road vehicles — Environmental conditions and testing for electrical and electronic equipment — Part 2: Electrical loads |
| ISO 16750-4:2010 | Road vehicles — Environmental conditions and testing for electrical and electronic equipment — Part 4: Climatic loads |
| ISO 16750-5:2010 | Road vehicles — Environmental conditions and testing for electrical and electronic equipment — Part 5: Chemical loads |
| ISO 16750-1:2006 | Road vehicles Environmental conditions and testing for electrical and electronic equipment Part 1: General |
| ISO 8092-2:2005 | Road vehicles — Connections for on-board electrical wiring harnesses — Part 2: Definitions, test methods and general performance requirements |
| ISO 20653:2013 | Road vehicles — Degrees of protection (IP code) — Protection of electrical equipment against foreign objects, water and access |
| ISO 16750-3:2012 | Road vehicles — Environmental conditions and testing for electrical and electronic equipment — Part 3: Mechanical loads |
| ISO 178:2010 | Plastics Determination of flexural properties |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.