16/30341843 DC : 0

FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Definitions
4 General requirements
5 General notes on tests
6 Classification
7 Marking
8 Protection against accidental contact
   with live parts
9 Terminals
10 Provisions for earthing
11 Moisture resistance and insulation
12 Electric strength
13 Thermal endurance test for windings
14 Fault conditions
15 Protection of associated components
16 Abnormal conditions
17 Construction
18 Creepage distances and clearances
19 Screws, current-carrying parts and connections
20 Resistance to heat, fire and tracking
Annex A (normative) - Test to establish whether a
        conductive part is a live part which may
        cause an electric shock
Annex B (normative) - Particular requirements for
        thermally protected lamp controlgear
Annex C (normative) - Particular requirements for electronic
        lamp controlgear with means of protection against
        overheating
Annex D (normative) - Requirements for carrying out the
        heating tests of thermally protected lamp controlgear
Annex E (normative) - Use of constant S other than 4500 in
        t[w] tests
Annex F (normative) - Draught-proof enclosure
Annex G (normative) - Explanation of the derivation of the
        values of pulse voltages
Annex H (normative) - Tests
Annex I (normative) - Measurement of high-frequency
        leakage current
Annex J (normative) - Particular additional safety
        requirements for a.c., a.c./d.c. or d.c supplied
        electronic controlgear for emergency lighting
Annex K (informative) - Conformity testing during
        manufacture
Annex L (normative) - Particular additional requirements
        for controlgear providing SELV
Annex M (informative) - Dielectric strength test voltages
        for controlgear intended for the use in impulse
        withstand Category III
Annex N (normative) - Requirements for insulation
        materials used for double or reinforced insulation
Annex O (normative) - Additional requirements for
        built-in electronic controlgear with double or
        reinforced insulation
Annex P (normative) - Creepage distances and
        clearances and distance through insulation
         (DTI) for lamp controlgear which are protected
        against pollution by the use of coating or potting
Annex Q (informative) - Example for Up calculation
Annex R (informative) - Concept of creepage distances
        and clearances
Annex S (informative) - Examples of controlgear
        insulation coordination
Annex T (informative) - Creepage distances and
        clearances for controlgear with a higher
        degree of availability (impulse withstand category III)

BS EN 61347-2-14.