AGMA ISO 6336-6 : A2008(R2014)

Withdrawn

Withdrawn A Withdrawn Standard is one, which is removed from sale, and its unique number can no longer be used. The Standard can be withdrawn and not replaced, or it can be withdrawn and replaced by a Standard with a different number.

CALCULATION OF LOAD CAPACITY OF SPUR AND HELICAL GEARS - PART 6: CALCULATION OF SERVICE LIFE UNDER VARIABLE LOAD

Available format(s):

Withdrawn date: 06-11-2023

Language(s):

Published date: 12-01-2013

Publisher: American Gear Manufacturers Association

Table of Contents - (Show below) - (Hide below)

Foreword
1 Scope
2 Normative references
3 Terms, definitions, symbols and abbreviated terms
4 General
5 Calculation according to ISO 6336 of service strength
  on basis of single-stage strength
Bibliography
Annexes
Annex A (normative) Determination of application factor,
        K[A], from given load spectrum using equivalent
        torque, T[eq]
Annex B (informative) Guide values for application factor,
        K[A] Annex C (informative) Example calculation of
        safety factor from given load spectrum
Bibliography

Abstract - (Show below) - (Hide below)

Describes the information and standardized conditions necessary for the calculation of the service life (or safety factors for a required life) of gears subject to variable loading.

General Product Information - (Show below) - (Hide below)

Document Type	Standard
ISBN
Pages
Published
Publisher	American Gear Manufacturers Association
Status	Withdrawn

International Equivalents – Equivalent Standard(s) & Relationship - (Show below) - (Hide below)

Equivalent Standard(s)	Relationship
ISO 6336-6:2006	Identical

Standards Referenced By This Book - (Show below) - (Hide below)

AGMA 6013:2016(R2021)	INDUSTRIAL ENCLOSED GEAR DRIVES
AGMA 6123 : REV A : 1988	DESIGN MANUAL FOR ENCLOSED EPICYCLIC GEAR DRIVES
AGMA 6123 : REV A : 2006	DESIGN MANUAL FOR ENCLOSED EPICYCLIC GEAR DRIVES
AGMA 6123 : REV A : 1988 : R2000	DESIGN MANUAL FOR ENCLOSED EPICYCLIC GEAR DRIVES

Standards Referencing This Book - (Show below) - (Hide below)

ISO 6336-2:2006	Calculation of load capacity of spur and helical gears Part 2: Calculation of surface durability (pitting)
ISO 701:1998	International gear notation Symbols for geometrical data
ISO 6336-3:2006	Calculation of load capacity of spur and helical gears Part 3: Calculation of tooth bending strength
ISO 6336-1:2006	Calculation of load capacity of spur and helical gears Part 1: Basic principles, introduction and general influence factors

Categories associated with this Standard - (Show below) - (Hide below)

Sub-Categories associated with this Standard - (Show below) - (Hide below)

Sorry this product is not available in your region.

Add To Cart