ANSI INCITS 293 : 1996 : R2001
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
INFORMATION TECHNOLOGY - SERIAL STORAGE ARCHITECTURE PHYSICAL LAYER 1 (SSA-PH1)
Hardcopy , PDF
23-08-2015
English
01-01-2006
Foreword
Introduction
1 Scope
1.1 SSA-PH1 characteristics
1.2 SSA family of standards
2 Normative references
3 Definitions, symbols, and abbreviations
3.1 Definitions
3.2 Symbols and abbreviations
4 Conventions
5 Modulation
6 Data rate
7 Electrical requirements
7.1 Line driver
7.2 Line receiver
7.3 Line segment termination
7.4 Ground shift
7.5 Port connection
7.6 System level noise margin
8 Interconnections
8.1 Internal connectors
8.2 Internal port connections
8.3 Internal options bay connections
8.4 Internal device power connections
8.5 External connections
Annexes
A Transfer impedance testing procedure
B Internal connector testing procedure
C External connector testing procedure
D Line fault detection scheme examples
E Circuit for degrading signal amplitude and introducing common
mode levels
F Preferred test configurations for SSA links
G Implementation guidelines
H Reference for copper, polymer dielectric, non-equalized SSA
cable assemblies
Specifies the physical layer of the Serial Storage Architecture (SSA).
| Committee |
X3T10
|
| DocumentType |
Standard
|
| Pages |
95
|
| ProductNote |
Reconfirmed 2001
|
| PublisherName |
Information Technology Industry Council
|
| Status |
Superseded
|
| SupersededBy |
| IEC 60512-6:1984 | Electromechanical components for electronic equipment; basic testing procedures and measuring methods. Part 6: Climatic tests and soldering tests |
| IEC 60512-7:1993 | Electromechanical components for electronic equipment; basic testing procedures and measuring methods - Part 7: Mechanical operating tests and sealing tests |
| IEC 60512-11-7:2003 | Connectors for electronic equipment - Tests and measurements - Part 11-7: Climatic tests - Test 11g: Flowing mixed gas corrosion test |
| IEC 60512-4:1976 | Electromechanical components for electronic equipment; basic testing procedures and measuring methods. Part 4: Dynamic stress tests |
| IEC 60512-5:1992 | Electromechanical components for electronic equipment; basic testing procedures and measuring methods - Part 5: Impact tests (free components), static load tests (fixed components), endurance tests and overload tests |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.