AS 1359.2-1981

1 - AS 1359.2-1981 GENERAL REQUIREMENTS FOR ROTATING ELECTRICAL MACHINES - DIMENSIONAL SYMBOLS
3 - PREFACE
3 - CONTENTS
4 - CLAUSES
4 - 2.1 SCOPE.
4 - 2.2 SYMBOLS FOR DIMENSIONS OF MACHINES AND SLIDE RAILS.
4 - 2.3 ILLUSTRATIVE SKETCHES.
4 - TABLES
4 - TABLE 2.1 - SINGLE-LETTER SYMBOLS FOR DIMENSIONS OF MACHINES
5 - TABLE 2.2 - DOUBLE-LETTER SYMBOLS FOR DIMENSIONS OF MACHINES AND OF SLIDE RAILS
6 - FIGURES
6 - Fig. 2.1. SYMBOLS FOR FOOT-MOUNTED FRAMES
6 - Fig. 2.2. SYMBOLS FOR FLANGE-MOUNTED FRAMES
7 - Fig. 2.3. SYMBOLS FOR SKIRT-MOUNTED FRAMES
8 - Fig. 2.4. SYMBOLS FOR FACE-FLANGE-MOUNTED FRAMES
8 - Fig. 2.5. SYMBOLS FOR PAD/ROD-MOUNTED FRAMES
9 - Fig. 2.6. SYMBOLS FOR SHAFT EXTENSIONS WITH KEYWAYS
9 - Fig. 2.7. SYMBOLS FOR SHAFT EXTENSIONS WITH FLATS
9 - Fig. 2.8. SYMBOL FOR TAPPED HOLE IN SHAFT EXTENSION
10 - Fig. 2.9. SYMBOLS FOR SLIDE RAILS

Specifies letter symbols for the principal dimensions of machines and slide rails.

This Part of this standard specifies the symbols for the principal dimensions of machines and slide rails. The use of dimensional symbols is illustrated by typical sketches.NOTE: The allocation of symbols is somewhat arbitrary, being derived from past practice in relation to the smaller sizes of a.c. industrial motors. Nevertheless the symbols should be applied to all cases that they can adequately cover.

First published as part of AS C332.1-1963.
AS C332.2 first published 1963.
AS 1017 first published 1971.
AS C332.1-1963, AS C332.2-1963 and AS 1017-1971 revised, amalgamated and redesignated AS 1360.10-1975.
Revised and redesignated in part as AS 1359.2-1981.