AS 60068.2.61-2003

1 - AS 60068.2.61-2003 ENVIRONMENTAL TESTING - TESTS-TEST Z/ABDM: CLIMATIC SEQUENCE
4 - PREFACE
5 - CONTENTS
6 - INTRODUCTION
7 - 1 Scope
7 - 2 Normative references
8 - 3 Definitions
8 - 4 Test apparatus
8 - 5 Severities
8 - 6 Preconditioning
8 - 7 Initial measurements
9 - 8 Testing
9 - 8.1 General description
9 - 8.2 Method 1
9 - 8.2.1 Step 1: Dry heat
9 - 8.2.2 Step 2: Damp heat
9 - 8.2.3 Step 3: Cold
10 - 8.2.4 Step 4 (optional): Low air pressure
10 - 8.2.5 Step 5: Damp heat
10 - 8.3 Method 2
11 - 8.4 Method 3
11 - 9 Recovery
11 - 10 Final measurements
12 - 11 Information to be given in the relevant specification
13 - Annex A - Guidance for specification writers
13 - A.1 Intermediate measurements
13 - A.2 Recovery
14 - Annex B - Guidance for the conduct of the test
14 - B.1 Schedule of operations
14 - B.2 Precautions
14 - B.3 Use of a single test chamber

Provides standard composite test methods for determining the suitability of a specimen when subjected to environmental conditions consisting of a sequence of temperature, humidity and, where required, low air pressure environmental stresses.

This International Standard provides standard composite test methods for determining the suitability of a specimen when subjected to environmental conditions consisting of a sequence of temperature, humidity and, where required, low air pressure environmental stresses.The order of application of the stresses and conditions for the change from one step to the next have been chosen to accelerate and amplify degradation mechanisms of the same type as those observed under natural climatic conditions.NOTE Environmental conditions occurring in nature are classified in IEC 60721-2 and IEC 60721-3.This standard may be applied to other electrotechnical products when the degradation mechanisms are the same and the specified requirements for testing can be satisfied. In other cases, it may form a basis for the writing of a similar test.In this test, specimens are exposed to environmental tests in a standard order and categorized according to the basic code defined in annex A of IEC 60068-1 except that the third group of digits is used as an indication of the number of cycles in step 5 of the damp heat cyclic Test Db according to clause 6 in IEC 60068-2-30. In the climatic categories -/-/56, 40/-/-, etc., in this standard the dashes may be replaced by any of the standard values appropriate to the space as in the following examples: 55/100/56, 25/085/56, 40/085/21. Where any modification is necessary, the relevant specification shall provide the necessary information for each step in the selected method (see clause 8).This test is frequently specified to follow other tests involving mechanical stress, for example tests for robustness of terminations, solderability, shock and vibration, as a means of determining whether the sealing of the specimen has been damaged.

First published as AS 60068.2.61-2003.