ASTM A 134 : 1996
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Specification for Pipe, Steel, Electric-Fusion (Arc)-Welded (Sizes NPS 16 and Over)
Hardcopy , PDF
11-11-2014
English
31-12-2010
Important note : Users cannot be edited or removed once added to your Multi user PDF.CONTAINED IN VOL. 01.01, 2017 Describes the electric-fusion (arc)-welded spiral seam or straight seam steel pipe NPS 16 and over diameter, wall thicknesses up to 3/4 in. (19.0 mm), inclusive.
| Committee |
A 01
|
| DevelopmentNote |
Supersedes FED STD 48 (02/2004)
|
| DocumentType |
Standard
|
| Pages |
4
|
| ProductNote |
Reconfirmed 1996
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy |
1.1 This specification covers electric-fusion (arc)-welded straight seam or spiral seam steel pipe NPS 16 and over in diameter (inside or outside as specified by purchaser), with wall thicknesses up to 3/4 in. (19.0 mm), inclusive. Pipe having other dimensions may be furnished provided such pipe complies with all other requirements of this specification.
Note 1—Acceptability for many services may be controlled by codes or standards such as those published by the American National Standards Institute and American Society of Mechanical Engineers.
Note 2—For testing methods not specifically covered in this specification, reference can be made to Test Methods and Definitions A 370, with particular reference to Annex A 2 on Steel Tubular Products. Note 3—A comprehensive listing of standardized pipe dimensions is contained in ANSI B 36.10.1.2 The values stated in inch-pound units are to be regarded as the standard.
Note 4—The dimensionless designator NPS (nominal pipe size) has been substituted in this standard for such traditional terms as "nominal diameter", "size", and "nominal size".
1.3 The following precautionary caveat pertains specifically to Section 5 of this specification.This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
| ASTM F 1155 : 2010 : R2019 | Standard Practice for Selection and Application of Piping System Materials |
| ASME PV CODE 9 : 2017 | BOILER AND PRESSURE VESSEL CODE - WELDING, BRAZING, AND FUSING QUALIFICATIONS - QUALIFICATION STANDARD FOR WELDING, BRAZING, AND FUSING PROCEDURES; WELDERS; BRAZERS; AND WELDING, BRAZING, AND FUSING OPERATORS |
| ASME B36.10 : 1979 | WELDED AND SEAMLESS WROUGHT STEEL PIPE |
| ASME B16.25 : 2012 | BUTTWELDING ENDS |
| ASTM A 285/A285M : 2017 : REDLINE | Standard Specification for Pressure Vessel Plates, Carbon Steel, Low- and Intermediate-Tensile Strength |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.