ASTM A 874/A874M : 1998 : R2004
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Specification for Ferritic Ductile Iron Castings Suitable for Low-Temperature Service
Hardcopy , PDF
11-11-2014
English
01-10-2004
Important note : Users cannot be edited or removed once added to your Multi user PDF.CONTAINED IN VOL. 01.02, 2017 Defines ductile iron castings suitable for service at temperatures of -40 degrees F (-40 degrees C) and above.
| Committee |
A 04
|
| DevelopmentNote |
Supersedes ASTM A 874. (10/2009)
|
| DocumentType |
Standard
|
| Pages |
3
|
| ProductNote |
Reconfirmed 2004
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1 This specification covers ductile iron castings suitable for service at temperatures of 40°F [-40°C] and above.
1.2 The values stated in either inch-pound or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.
1.3 The following precautionary statement pertains only to the test methods portion, Section , of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
| ASTM E 689 : 2015 : REDLINE | Standard Reference Radiographs for Ductile Iron Castings |
| ASTM E 562 : 2011 : REDLINE | Standard Test Method for Determining Volume Fraction by Systematic Manual Point Count |
| ASTM E 30 : 1989 | Test Methods for Chemical Analysis of Steel, Cast Iron, Open-Hearth Iron, and Wrought Iron (Withdrawn 1995) |
| ASTM E 8 : 2004 | Standard Test Methods for Tension Testing of Metallic Materials |
| ASTM E 709 : 2015 : REDLINE | Standard Guide for Magnetic Particle Testing |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.