ASTM C 92 : 1995 : R2022 : EDT 1
Current
The latest, up-to-date edition.
Standard Test Methods for Sieve Analysis and Water Content of Refractory Materials
Hardcopy , PDF
English
22-04-2022
Important note : Users cannot be edited or removed once added to your Multi user PDF.| Committee |
C 08
|
| DocumentType |
Test Method
|
| Pages |
4
|
| ProductNote |
ε1NOTE—The title “ASTM Sieves” was added over the first column of Table 1 editorially in April 2022
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Current
|
| Supersedes |
1.1These test methods cover a wet and a dry method for sieve analysis of refractory materials.
1.1.1Wet Sieve Analysis—Water promotes the slaking of clays and helps to separate fine particles, washing them from the larger grains. This method is recommended for use with materials that require water addition, and that slake in normal industrial use.
1.1.2Dry Sieve Analysis—The dry method is not as effective as the wet method in determining the amount of material present in the smaller particle sizes. It is recommended (1) for clays, when the slaking action of water is undesirable, (2) when the material is in the form of coarsely ground grog and calcine, and (3) when the clay is to be used in such a way that the ultimate particle size is of secondary importance.
1.2These test methods also cover determination of the water content of refractory materials in the wet condition and of air-dried samples as received, so that the sieve analysis can be calculated on the dry basis. Included is a method for obtaining the water content of other refractory materials, such as plastic refractories and wet mixes.
1.3The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
| ASTM C 492 : 1992 : R2017 : EDT 1 | Standard Test Method for Hydration of Granular Dead-Burned Refractory Dolomite |
| ASTM C 1662 : 2018 | Standard Practice for Measurement of the Glass Dissolution Rate Using the Single-Pass Flow-Through Test Method |
| ASTM C 1285 : 2021 | Standard Test Methods for Determining Chemical Durability of Nuclear, Hazardous, and Mixed Waste Glasses and Multiphase Glass Ceramics: The Product Consistency Test (PCT) |
| ASTM C 429 : 2021 | Standard Test Method for Sieve Analysis of Raw Materials for Glass Manufacture |
| ASTM F 1097 : 2017 : R2022 | Standard Specification for Mortar, Refractory (High-Temperature, Air-Setting) |
| ASTM C 544 : 2018 | Standard Test Method for Hydration of Dead-Burned Magnesite or Periclase Grain |
| ASTM E 11 : 2024 | Standard Specification for Woven Wire Test Sieve Cloth and Test Sieves |
| ASTM E 11 : 2022 | Standard Specification for Woven Wire Test Sieve Cloth and Test Sieves |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.