ASTM D 4017 : 2002 : R2015
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Test Method for Water in Paints and Paint Materials by Karl Fischer Method
Hardcopy , PDF
15-12-2022
English
12-06-2015
Important note : Users cannot be edited or removed once added to your Multi user PDF.CONTAINED IN VOL. 06.01, 2017 Describes all paints and paint materials, including resins, monomers, and solvents, with the exception of aldehydes and certain active metals, metal oxides, and metal hydroxides.
| Committee |
D 01
|
| DocumentType |
Test Method
|
| Pages |
8
|
| ProductNote |
Reconfirmed 2015
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1This test method is applicable to all paints and paint materials, including resins, monomers, and solvents, with the exception of aldehydes and certain active metals, metal oxides, and metal hydroxides. While the evaluation was limited to pigmented products containing amounts of water in the 30 to 70 % range, there is reason to believe that higher and lower concentrations can be determined by this test method.
1.2The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.3This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazard statements are given in Section 7.
| ASTM D 6336 : 2011 : R2017 | Standard Practice for Evaluation of Flushing Vehicles for Pigment Wetting Using a Vacuum Modified Sigma Blade Mixer |
| ASTM D 5325 : 2003 : R2014 | Standard Test Method for Determination of Weight Percent Volatile Content of Water-Borne Aerosol Paints |
| ASTM D 6577 : 2015 | Standard Guide for Testing Industrial Protective Coatings |
| ASTM D 7245 : 2009 : R2014 | Standard Test Method for Measuring Total Water and Volatiles in Liquid Coatings Which Produce Cure Water Upon Heating |
| ASTM D 3451 : 2006 : R2017 | Standard Guide for Testing Coating Powders and Powder Coatings |
| ASTM D 6763 : 2016 | Standard Guide for Testing Exterior Wood Stains and Clear Water Repellents |
| ASTM D 6266 : 2000 : REV A : R2017 | Standard Test Method for Determining the Amount of Volatile Organic Compound (VOC) Released From Waterborne Automotive Coatings and Available for Removal in a VOC Control Device (Abatement) |
| ASTM D 4143 : 2016 | Standard Guide for Testing Latex Vehicles |
| ASTM D 7270 : 2007 : R2013 | Standard Guide for Environmental and Performance Verification of Factory-Applied Liquid Coatings |
| ASTM D 5324 : 2016 | Standard Guide for Testing Water-Borne Architectural Coatings |
| ASTM D 2827 : 2019 | Standard Specification for Styrene Monomer |
| ASTM D 5530 : 2015 | Standard Test Method for Total Moisture of Hazardous Waste Fuel by Karl Fischer Titrimetry |
| ASTM D 7358 : 2007 : R2018 | Standard Test Method for Water Content of Paints by Quantitative Calcium Hydride Reaction Test Kit |
| ASTM D 5871 : 2017 | Standard Specification for Benzene for Cyclohexane Feedstock |
| ASTM D 6336 : 2011 : R2021 | Standard Practice for Evaluation of Flushing Vehicles for Pigment Wetting Using a Vacuum Modified Sigma Blade Mixer |
| ASTM D 4143 : 2016 : R2022 | Standard Guide for Testing Latex Vehicles |
| ASTM D 7245 : 2009 : R2021 | Standard Test Method for Measuring Total Water and Volatiles in Liquid Coatings Which Produce Cure Water Upon Heating |
| ASTM D 7270 : 2007 : R2021 | Standard Guide for Environmental and Performance Verification of Factory-Applied Liquid Coatings |
| ASTM E 1868 : 2010 : R2021 | Standard Test Methods for Loss-On-Drying by Thermogravimetry |
| ASTM D 5530 : 2022 | Standard Test Method for Total Moisture of Hazardous Waste Fuel by Karl Fischer Titrimetry |
| ASTM D 5325 : 2003 : R2021 | Standard Test Method for Determination of Weight Percent Volatile Content of Water-Borne Aerosol Paints |
| ASTM D 6577 : 2015 : R2019 | Standard Guide for Testing Industrial Protective Coatings |
| ASTM D 5146 : 2010 : R2019 | Standard Guide to Testing Solvent-Borne Architectural Coatings |
| ASTM D 6511/D6511M : 2018 | Standard Test Methods for Solvent Bearing Bituminous Compounds |
| ASTM E 203 : 2016 | Standard Test Method for Water Using Volumetric Karl Fischer Titration |
| ASTM D 6886 : 2018 | Standard Test Method for Determination of the Weight Percent Individual Volatile Organic Compounds in Waterborne Air-Dry Coatings by Gas Chromatography |
| ASTM E 1868 : 2010 : R2015 | Standard Test Methods for Loss-On-Drying by Thermogravimetry |
| ASTM D 3960 : 2005 : R2018 | Standard Practice for Determining Volatile Organic Compound (VOC) Content of Paints and Related Coatings |
| ASTM D 3960 : 2005 : R2018 | Standard Practice for Determining Volatile Organic Compound (VOC) Content of Paints and Related Coatings |
| ASTM D 3960 : 2002 | Standard Practice for Determining Volatile Organic Compound (VOC) Content of Paints and Related Coatings |
| ASTM D 3960 : 2001 | Standard Practice for Determining Volatile Organic Compound (VOC) Content of Paints and Related Coatings |
| ASTM D 3960 : 2005 | Standard Practice for Determining Volatile Organic Compound (VOC) Content of Paints and Related Coatings |
| ASTM D 1193 : 1977 : R1983 : EDT 1 | Standard Specification for Reagent Water |
| ASTM D 3960 : 2005 : R2013 | Standard Practice for Determining Volatile Organic Compound (VOC)Content of Paints and Related Coatings |
| ASTM D 1193 : 2006 : R2011 | Standard Specification for Reagent Water |
| ASTM E 180 : 2003 | Standard Practice for Determining the Precision of ASTM Methods for Analysis and Testing of Industrial and Specialty Chemicals (Withdrawn 2009) |
| ASTM D 3960 : 1998 | Standard Practice for Determining Volatile Organic Compound (VOC) Content of Paints and Related Coatings |
| ASTM D 1193 : 1991 | Standard Specification for Reagent Water |
| ASTM D 1193 : 1970 | Standard Specification For Reagent Water |
| ASTM E 203 : 2016 : REDLINE | Standard Test Method for Water Using Volumetric Karl Fischer Titration |
| ASTM D 1193 : 2006 | Standard Specification for Reagent Water |
| ASTM D 3960 : 2004 | Standard Practice for Determining Volatile Organic Compound (VOC) Content of Paints and Related Coatings |
| ASTM D 1193 : 1999 | Standard Specification for Reagent Water |
| ASTM D 1193 : 2006 : R2018 | Standard Specification for Reagent Water |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.