1.1These test methods cover the methods and procedures for testing electrically insulating and semi-nonmetallic conducting rubber tapes designed for splicing, terminating, and sheath repair of electrical wire and cable.
1.2The test methods appear in the following sections:
| | Section |
| Referenced Documents | 2 |
| Conditioning | 5-6 |
| Dielectric Strength | 35 – 40 |
| Dimensions | 11 – 16 |
| Dissipation Factor | 22 – 26 |
| Elongation | 17 – 21 |
| Heat Exposure | 46 – 49 |
| Fusion | 7 – 10 |
| Ozone Resistance | 41 – 45 |
| Permittivity | 22 – 26 |
| Sample Requirements | 4 |
| Tensile Strength | 17 – 21 |
| Volume Resistivity | 27 – 34 |
| Ultraviolet and Weather Resistance | 50 – 54 |
1.3The values stated in SI units are to be regarded as standard. The values given in parentheses are mathematical conversions to inch-pound units that are provided for information only and are not considered standard.
Note 1—There is no IEC equivalent to these methods.
1.4Unless otherwise stated, measurements are made on tapes from which the removable separator has been removed.
1.5This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precaution statements see 43.1.
1.6This is a fire-test response standard.