ASTM D 4552/D4552M : 2010
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Practice for Classifying Hot-Mix Recycling Agents
Hardcopy , PDF
11-11-2014
English
15-06-2010
CONTAINED IN VOL. 04.03, 2016 Defines a standardized method whereby petroleum product additives to be used in hot recycling of asphalt concrete can be identified.
Committee |
D 04
|
DevelopmentNote |
Supersedes ASTM D 4552. (08/2010)
|
DocumentType |
Standard Practice
|
Pages |
2
|
ProductNote |
Reconfirmed 2010
|
PublisherName |
American Society for Testing and Materials
|
Status |
Superseded
|
SupersededBy | |
Supersedes |
1.1 This practice covers a standardized method whereby petroleum product additives to be used in hot recycling of asphalt concrete can be identified. The products are classified by viscosity in mm2/s measured at 60°C [140°F]. This practice does not apply to emulsified materials.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
ASTM D 1754 : 1997 | Standard Test Method for Effect of Heat and Air on Asphaltic Materials (Thin-Film Oven Test) |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.