ASTM D 522/D522M : 2017 : REDLINE
Current
The latest, up-to-date edition.
Standard Test Methods for Mandrel Bend Test of Attached Organic Coatings
English
12-09-2017
Important note : Users cannot be edited or removed once added to your Multi user PDF.CONTAINED IN VOL. 06.01, 2017 Defines the determination of the resistance to cracking (flexibility) of attached organic coatings on substrates of sheet metal or rubber-type materials.
| Committee |
D 01
|
| DevelopmentNote |
Supersedes ASTM D 522. (01/2014)
|
| DocumentType |
Redline
|
| Pages |
6
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Current
|
| Supersedes |
1.1These test methods cover the determination of the resistance to cracking (flexibility) of attached organic coatings on substrates of sheet metal or rubber-type materials.
1.2The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
| MIL-PRF-32577 Base Document:2017 | Coating System, Nonskid, Metallic Thermal Spray Application |
| MIL-PRF-32440 Base Document:2013 | COATINGS, CHIP-, IMPACT-, WEAR-, AND ABRASION-RESISTANT |
| SSPC-PS 26.00 : 2016 | Aluminum-Pigmented Epoxy Coating System Materials Standard, Performance-Based; Type I for Use Over Blast Cleaned Steel; Type II for Use Over Hand-Cleaned Steel |
| ANSI/AWWA C224 : 2017 | NYLON-11-BASED POLYAMIDE COATINGS AND LININGS FOR STEEL WATER PIPE AND FITTINGS |
| MIL-PRF-32550 Base Document:2016 | METAL-RICH PRIMER |
| ASTM E 1795 : 2017 : REDLINE | Standard Specification for Non-Reinforced Liquid Coating Encapsulation Products for Leaded Paint in Buildings |
| ASTM D 2205 : 2015 : REDLINE | Standard Guide for Selection of Tests for Traffic Paints |
| ASTM D 2370 : 2016 : REDLINE | Standard Test Method for Tensile Properties of Organic Coatings |
| ASTM D 823 : 1995 | Standard Practices for Producing Films of Uniform Thickness of Paint, Varnish, and Related Products on Test Panels |
| ASTM D 7091 : 2013 : REDLINE | Standard Practice for Nondestructive Measurement of Dry Film Thickness of Nonmagnetic Coatings Applied to Ferrous Metals and Nonmagnetic, Nonconductive Coatings Applied to Non-Ferrous Metals |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.