ASTM D 6511/D6511M : 2018
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Test Methods for Solvent Bearing Bituminous Compounds
Hardcopy , PDF
08-05-2024
English
10-05-2018
Important note : Users cannot be edited or removed once added to your Multi user PDF.| Committee |
D 08
|
| DocumentType |
Test Method
|
| Pages |
9
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1These test methods cover procedures for sampling and testing solvent bearing bituminous compounds for use in roofing and waterproofing.
1.2The test methods appear in the following order:
| Section | |
| Sampling | 4 |
| Uniformity | 5 |
| Weight per gallon | 6 |
| Nonvolatile content | 7 |
| Solubility | 8 |
| Ash content | 9 |
| Water content | 10 |
| Consistency | 11 |
| Behavior at 60°C [140°F] | 12 |
| Pliability at –0°C [32°F] | 13 |
| Aluminum content | 14 |
| Reflectance of aluminum roof coatings | 15 |
| Strength of laps of rolled roofing adhered with roof adhesive | 16 |
| Adhesion to damp, wet, or underwater surfaces | 17 |
| Mineral stabilizers and bitumen | 18 |
| Mineral matter | 19 |
| Volatile organic content | 20 |
1.3The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
| ASTM D 8464/D8464M : 2023 | Standard Specification for Cold-Applied Coal Tar for Roofing, Waterproofing, and Dampproofing |
| ASTM D 41/D41M : 2011 : R2023 | Standard Specification for Asphalt Primer Used in Roofing, Dampproofing, and Waterproofing |
| ASTM C 836/C836M : 2018 : R2022 | Standard Specification for High Solids Content, Cold Liquid-Applied Elastomeric Waterproofing Membrane for Use with Separate Wearing Course |
| ASTM D 6753/D6753M : 2002 : R2023 | Standard Specification for Coal Tar Adhesive |
| ASTM C 957/C957M : 2017 : R2024 | Standard Specification for High-Solids Content, Cold Liquid-Applied Elastomeric Waterproofing Membrane with Integral Wearing Surface |
| ASTM D 8463/D8463M : 2023 | Standard Specification for High Solids Content, Cold Liquid-Applied Elastomeric, Silyl-Terminated Polymer Based Waterproofing Membrane for Use with Separate Wearing Course |
| ASTM C 670 : 2024 | Standard Practice for Preparing Precision and Bias Statements for Test Methods for Construction Materials |
| ASTM D 4017 : 2002 : R2015 | Standard Test Method for Water in Paints and Paint Materials by Karl Fischer Method |
| ASTM D 4017 : 1981 : R1987 : EDT 1 | Standard Test Method for Water in Paints and Paint Materials by Karl Fischer Method |
| ASTM D 2369 : 1981 : EDT 1 | Standard Test Method for Volatile Content of Coatings |
| ASTM D 140/D140M : 2016 : R2023 | Standard Practice for Sampling Asphalt Materials |
| ASTM D 95 : 2013 : R2018 | Standard Test Method for Water in Petroleum Products and Bituminous Materials by Distillation |
| ASTM D 2369 : 2020 | Standard Test Method for Volatile Content of Coatings |
| ASTM D 1475 : 1960 : R1968 | Standard Method Of Test For Density Of Paint, Varnish, Lacquer, And Related Products |
| ASTM E 200 : 2016 | Standard Practice for Preparation, Standardization, and Storage of Standard and Reagent Solutions for Chemical Analysis |
| ASTM D 562 : 2010 : R2018 | Standard Test Method for Consistency of Paints Measuring Krebs Unit (KU) Viscosity Using a Stormer-Type Viscometer |
| ASTM E 200 : 2023 | Standard Practice for Preparation, Standardization, and Storage of Standard and Reagent Solutions for Chemical Analysis |
| ASTM D 2369 : 2024 | Standard Test Method for Volatile Content of Coatings |
| ASTM C 670 : 2024 : REV A | Standard Practice for Preparing Precision and Bias Statements for Test Methods for Construction Materials |
| ASTM D 140/D140M : 2016 | Standard Practice for Sampling Asphalt Materials |
| ASTM E 1 : 2014 : R2020 | Standard Specification for ASTM Liquid-in-Glass Thermometers |
| ASTM D 562 : 2010 : R2023 | Standard Test Method for Consistency of Paints Measuring Krebs Unit (KU) Viscosity Using a Stormer-Type Viscometer |
| ASTM D 4017 : 2022 | Standard Test Method for Water in Paints and Paint Materials by Karl Fischer Method |
| ASTM C 670 : 2015 | Standard Practice for Preparing Precision and Bias Statements for Test Methods for Construction Materials |
| ASTM D 95 : 2023 | Standard Test Method for Water in Petroleum Products and Bituminous Materials by Distillation |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.