• Shopping Cart
    There are no items in your cart

ASTM D 7192 : 2010

Superseded

Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by

Standard Test Method for High Speed Puncture Properties of Plastic Films Using Load and Displacement Sensors

Available format(s)

Hardcopy , PDF

Superseded date

16-11-2018

Superseded by

ASTM D 7192 : 2018

Language(s)

English

Published date

01-04-2010

€67.30
Excluding VAT

CONTAINED IN VOL. 08.03, 2015 Specifies the determination of puncture properties of plastic films, over a range of test velocities.

Committee
D 20
DocumentType
Test Method
Pages
8
PublisherName
American Society for Testing and Materials
Status
Superseded
SupersededBy
Supersedes

1.1 This test method covers the determination of puncture properties of plastic films, over a range of test velocities.

1.1.1 Test Method D1004 has defined film as having a thickness not greater than 0.25 mm. Plastic materials having a thickness above this limit are not to be excluded from use unless shown to be rigid (see 3.2.1). Test Method D3763 is the recommended method for instrumented puncture testing of rigid plastics.

1.2 Test data obtained by this test method is relevant and appropriate for use in engineering design.

1.3 The values stated in SI units are to be regarded as standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1—This test method does not closely conform to ISO 7765-2. The only similarity between the two tests is that they are both instrumented impact tests. The differences in striker, fixture, specimen geometries and in test velocity can produce significantly different test results.

ASTM D 8065/D8065M : 2016 Standard Classification System and Basis for Specification for Specifying Plastic Films

ASTM D 618 : 2013 : REDLINE Standard Practice for Conditioning Plastics for Testing
ASTM D 1004 : 2013 : REDLINE Standard Test Method for Tear Resistance (Graves Tear) of Plastic Film and Sheeting
ASTM D 6988 : 2013 : REDLINE Standard Guide for Determination of Thickness of Plastic Film Test Specimens
ASTM D 4000 : 2016 : REDLINE Standard Classification System for Specifying Plastic Materials

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.