ASTM E 1421 : 1999 : R2015 : EDT 1
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Practice for Describing and Measuring Performance of Fourier Transform Mid-Infrared (FT-MIR) Spectrometers: Level Zero and Level One Tests
Hardcopy , PDF
16-09-2021
English
17-07-2015
Important note : Users cannot be edited or removed once added to your Multi user PDF.CONTAINED IN VOL. 03.06, 2015 Specifies two levels of tests to measure the performance of laboratory Fourier transform mid-infrared (FT-MIR) spectrometers equipped with a standard sample holder used for transmission measurements.
| Committee |
E 13
|
| DocumentType |
Standard Practice
|
| Pages |
12
|
| ProductNote |
Reconfirmed EDT 1
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1This practice describes two levels of tests to measure the performance of laboratory Fourier transform mid-infrared (FT-MIR) spectrometers equipped with a standard sample holder used for transmission measurements.
1.2This practice is not directly applicable to Fourier transform infrared (FT-IR) spectrometers equipped with various specialized sampling accessories such as flow cells or reflectance optics, nor to Fourier transform near-infrared (FT-NIR) spectrometers, nor to FT-IR spectrometers run in step scan mode.
1.2.1If the specialized sampling accessory can be removed and replaced with a standard transmission sample holder, then this practice can be used. However, the user should recognize that the performance measured may not reflect that which is achieved when the specialized accessory is in use.
1.2.2If the specialized sampling accessory cannot be removed, then it may be possible to employ a modified version of this practice to measure spectrometer performance. The user is referred to Guide E1866 for a discussion of how these tests may be modified.
1.2.3Spectrometer performance tests for FT-NIR spectrometers are described in Practice E1944.
1.2.4Performance tests for dispersive MIR instruments are described in Practice E932.
1.2.5For FT-IR spectrometers run in a step scan mode, variations on this practice and information provided by the instrument vendor should be used.
1.3The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.3.1Exception—Informational inch-pound units are provided in 5.4.
1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
| ASTM E 2106 : 2000 : R2011 | Standard Practice for General Techniques of Liquid Chromatography-Infrared (LC/IR) and Size Exclusion Chromatography-Infrared (SEC/IR) Analyses |
| ASTM E 2056 : 2004 : R2016 | Standard Practice for Qualifying Spectrometers and Spectrophotometers for Use in Multivariate Analyses, Calibrated Using Surrogate Mixtures |
| ASTM D 7418 : 2012 | Standard Practice for Set-Up and Operation of Fourier Transform Infrared (FT-IR) Spectrometers for In-Service Oil Condition Monitoring |
| ASTM E 1944 : 1998 : R2013 | Standard Practice for Describing and Measuring Performance of Laboratory Fourier Transform Near-Infrared (FT-NIR) Spectrometers: Level Zero and Level One Tests |
| ASTM D 7214 : 2007 : REV A : R2012 | Standard Test Method for Determination of the Oxidation of Used Lubricants by FT-IR Using Peak Area Increase Calculation |
| ASTM E 1865 : 1997 : R2013 | Standard Guide for Open-Path Fourier Transform Infrared (OP/FT-IR) Monitoring of Gases and Vapors in Air |
| ASTM D 5576 : 2000 : R2013 | Standard Practice for Determination of Structural Features in Polyolefins and Polyolefin Copolymers by Infrared Spectrophotometry (FT-IR) |
| ASTM D 6047 : 2017 | Standard Test Methods for Rubber, Raw—Determination of 5-Ethylidenenorbornene (ENB) or Dicyclopentadiene (DCPD) in Ethylene-Propylene-Diene (EPDM) Terpolymers |
| ASTM E 1642 : 2000 : R2016 | Standard Practice for General Techniques of Gas Chromatography Infrared (GC/IR) Analysis |
| ASTM E 1866 : 1997 : R2013 | Standard Guide for Establishing Spectrophotometer Performance Tests |
| ASTM F 2381 : 2010 | Standard Test Method for Evaluating Trans-Vinylene Yield in Irradiated Ultra-High-Molecular-Weight Polyethylene Fabricated Forms Intended for Surgical Implants by Infrared Spectroscopy |
| ASTM E 1982 : 1998 : R2013 | Standard Practice for Open-Path Fourier Transform Infrared (OP/FT-IR) Monitoring of Gases and Vapors in Air |
| ASTM E 168 : 2016 | Standard Practices for General Techniques of Infrared Quantitative Analysis |
| ASTM E 1655 : 2017 | Standard Practices for Infrared Multivariate Quantitative Analysis |
| ASTM E 2937 : 2018 | Standard Guide for Using Infrared Spectroscopy in Forensic Paint Examinations |
| ASTM E 3085 : 2017 | Standard Guide for Fourier Transform Infrared Spectroscopy in Forensic Tape Examinations |
| ASTM E 2412 : 2010 : R2018 | Standard Practice for Condition Monitoring of In-Service Lubricants by Trend Analysis Using Fourier Transform Infrared (FT-IR) Spectrometry |
| ASTM E 1252 : 1998 : R2013 : EDT 1 | Standard Practice for General Techniques for Obtaining Infrared Spectra for Qualitative Analysis |
| ASTM E 2224 : 2019 | Standard Guide for Forensic Analysis of Fibers by Infrared Spectroscopy |
| ASTM D 5670 : 1995 : R2019 | Standard Test Method for Rubber—Determination of Residual Unsaturation in Hydrogenated Nitrile Rubber (HNBR) by Infrared Spectrophotometry |
| ASTM D 6645 : 2018 | Standard Test Method for Methyl (Comonomer) Content in Polyethylene by Infrared Spectrophotometry |
| ASTM E 2105 : 2000 : R2016 | Standard Practice for General Techniques of Thermogravimetric Analysis (TGA) Coupled With Infrared Analysis (TGA/IR) |
| ASTM E 1865 : 1997 : R2021 | Standard Guide for Open-Path Fourier Transform Infrared (OP/FT-IR) Monitoring of Gases and Vapors in Air |
| ASTM D 7418 : 2020 | Standard Practice for Set-Up and Operation of Fourier Transform Infrared (FT-IR) Spectrometers for In-Service Oil Condition Monitoring |
| ASTM E 2106 : 2000 : R2019 | Standard Practice for General Techniques of Liquid Chromatography-Infrared (LC/IR) and Size Exclusion Chromatography-Infrared (SEC/IR) Analyses |
| ASTM F 2381 : 2019 | Standard Test Method for Evaluating Trans-Vinylene Yield in Irradiated Ultra-High Molecular Weight Polyethylene Fabricated Forms Intended for Surgical Implants by Infrared Spectroscopy |
| ASTM D 6122 : 2021 | Standard Practice for Validation of the Performance of Multivariate Online, At-Line, Field and Laboratory Infrared Spectrophotometer, and Raman Spectrometer Based Analyzer Systems |
| ASTM D 7399 : 2018 | Standard Test Method for Determination of the Amount of Polypropylene in Polypropylene/Low Density Polyethylene Mixtures Using Infrared Spectrophotometry |
| ASTM E 1982 : 1998 : R2021 | Standard Practice for Open-Path Fourier Transform Infrared (OP/FT-IR) Monitoring of Gases and Vapors in Air |
| ASTM E 1252 : 1998 : R2021 | Standard Practice for General Techniques for Obtaining Infrared Spectra for Qualitative Analysis |
| ASTM D 5576 : 2000 : R2021 : EDT 1 | Standard Practice for Determination of Structural Features in Polyolefins and Polyolefin Copolymers by Infrared Spectrophotometry (FT-IR) |
| ASTM E 1866 : 1997 : R2002 | Standard Guide for Establishing Spectrophotometer Performance Tests |
| ASTM E 1944 : 1998 : R2002 | Standard Practice for Describing and Measuring Performance of Laboratory Fourier Transform Near-Infrared (FT-NIR) Spectrometers: Level Zero and Level One Tests |
| ASTM E 932 : 1989 : R2013 | Standard Practice for Describing and Measuring Performance of Dispersive Infrared Spectrometers |
| ASTM E 1866 : 1997 : R2007 | Standard Guide for Establishing Spectrophotometer Performance Tests |
| ASTM E 932 : 1989 : R2021 | Standard Practice for Describing and Measuring Performance of Dispersive Infrared Spectrometers |
| ASTM E 1944:1998 | Standard Practice for Describing and Measuring Performance of Laboratory Fourier Transform Near-Infrared (FT-NIR) Spectrometers: Level Zero and Level One Tests |
| ASTM E 1944 : 1998 : R2013 | Standard Practice for Describing and Measuring Performance of Laboratory Fourier Transform Near-Infrared (FT-NIR) Spectrometers: Level Zero and Level One Tests |
| ASTM E 1866 : 1997 : R2021 | Standard Guide for Establishing Spectrophotometer Performance Tests |
| ASTM E 1866 : 1997 | Standard Guide for Establishing Spectrophotometer Performance Tests |
| ASTM E 1944 : 1998 : R2007 | Standard Practice for Describing and Measuring Performance of Laboratory Fourier Transform Near-Infrared (FT-NIR) Spectrometers: Level Zero and Level One Tests |
| ASTM E 1866 : 1997 : R2013 | Standard Guide for Establishing Spectrophotometer Performance Tests |
| ASTM E 1944 : 1998 : R2021 | Standard Practice for Describing and Measuring Performance of Laboratory Fourier Transform Near-Infrared (FT-NIR) Spectrometers: Level Zero and Level One Tests |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.