ASTM E 1556 : 2012 : REDLINE
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Specification for Epoxy Resin System for Composite Skin, Honeycomb Sandwich Panel Repair
14-10-2020
English
01-11-2012
CONTAINED IN VOL. 04.11, 2015 Includes the requirements for an epoxy resin system meant for the repair of sandwich panels for durable, rigidwall, relocatable structures.
Committee |
E 06
|
DocumentType |
Redline
|
Pages |
11
|
PublisherName |
American Society for Testing and Materials
|
Status |
Superseded
|
SupersededBy |
1.1This specification covers the requirements for an epoxy resin system intended for the repair of sandwich panels for durable, rigidwall, relocatable structures. It must be usable in a field environment and shall not require the use of special equipment such as autoclaves or presses. The epoxy system covered by this specification shall be usable for simultaneous impregnation of a wet-layup composite skin and bonding of that skin to a substrate honeycomb core. The material shall withstand exposure to temperatures from −54 to 93°C (−65 to 199°F) and high relative humidity, and also the combination of stress, temperature, and relative humidity that are expected to be encountered in service.
1.2The values stated in SI units are to be regarded as standard where only SI units are given or where SI units are given first followed by inch-pound units; where inch-pound units are given first followed by SI units, the inch-pound units are to be regarded as the standard.
1.3The following safety hazards caveat refers only to the test methods described in this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
ASTM E 631 : 2015 : REDLINE | Standard Terminology of Building Constructions |
MIL-STD-129 Revision R:2014 | Military Marking for Shipment and Storage |
ASTM E 1091 : 2013 : REDLINE | Standard Specification for Nonmetallic Honeycomb Core for Use in Shelter Panels |
ASTM D 2344/D2344M : 2016 : REDLINE | Standard Test Method for Short-Beam Strength of Polymer Matrix Composite Materials and Their Laminates |
ASTM D 792 : 2013 : REDLINE | Standard Test Methods for Density and Specific Gravity (Relative Density) of Plastics by Displacement |
ASTM C 297/C297M : 2016 : REDLINE | Standard Test Method for Flatwise Tensile Strength of Sandwich Constructions |
MIL-STD-1916 Base Document:1996 | DOD PREFERRED METHODS FOR ACCEPTANCE OF PRODUCT |
ASTM D 2734 : 2016 : REDLINE | Standard Test Methods for Void Content of Reinforced Plastics |
SAE AMS C 9084 : 2013 | CLOTH, GLASS, FINISHED, FOR RESIN LAMINATES |
MIL-I-24768 Base Document:1992 | INSULATION, PLASTICS, LAMINATED, THERMOSETTING, GENERAL SPECIFICATION FOR |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.