BS 3416:1991
Current
The latest, up-to-date edition.
Specification for bitumen-based coatings for cold application, suitable for use in contact with potable water
Hardcopy , PDF
English
31-10-1991
Important note : Users cannot be edited or removed once added to your Multi user PDF.
Committees responsible
Foreword
Specification
1 Scope
2 Definitions
3 Classification
4 Sampling
5 Flash point
6 Drying and over-coating times
7 Finish
8 Protection against corrosion
9 Bend resistance
10 Effect on potable water
11 Shelf life
12 Marking
Appendices
A Guidance on the use of bitumen-based coatings for
cold application
B Methods of test for performance requirements
C Preparation and coating of test panels
Requirements for two types, each with three classes, of coatings all of which give films that comply with the national requirements for contact with potable water.
| Committee |
STI/21
|
| DevelopmentNote |
Supersedes 91/51890 DC, 92/50765 DC and BS 3416(1988) (07/2005) Supersedes TS 10195A. (11/2005) Reviewed and confirmed by BSI, October 2008. (09/2008)
|
| DocumentType |
Standard
|
| Pages |
12
|
| PublisherName |
British Standards Institution
|
| Status |
Current
|
This British Standard specifies performance and marking requirements for a range of bitumen-based solvent-borne coatings. It covers coatings for cold application by either brushing, spraying, rolling or dipping processes intended to give a coat for the corrosion protection and water-proofing of substrates including iron and steel.
Two types, each with three classes, are included. All of these give films that are suitable for use on potable water tanks and cisterns as well as for general applications.
The level of gloss of the finished film is not specified in this British Standard.
NOTE 1 These bitumen coatings are neither intended to withstand hot conditions, as on boilers, smoke stacks, etc., for which special coatings should be obtained, nor to resist contamination with mineral oils or paint solvents, all of which conditions will cause softening of the film.
NOTE 2 Guidance on the use of bitumen-based coatings is given in Appendix A, BS 5493 and BS 6150.
NOTE 3 The titles of the publications referred to in this standard are listed on the inside back cover.
| BS 5493:1977 | Code of practice for protective coating of iron and steel structures against corrosion |
| BS 6949:1991 | Specification for bitumen-based coatings for cold application excluding use in contact with potable water |
| BS 3900-H2:1983 | Methods of test for paints. Evaluation of paint and varnish defects Designation of degree of blistering |
| BS 3900-C2:1971 | Methods of test for paints. Tests associated with paint film formation Surface-drying test (ballotini method) |
| BS 2015:1965 | Glossary of paint terms |
| BS 6150:1991 | Code of practice for painting of buildings |
| BS 3900-A1:1970 | Methods of test for paints. Tests on liquid paints (excluding chemical tests) Sampling |
| BS 3900-E5:1973 | Methods of test for paints Pendulum damping test |
| BS 3900-F4:1968 | Methods of test for paints Resistance to continuous salt spray |
| BS 2523:1966 | Specification for lead-based priming paints |
| BS 245:1976 | Specification for mineral solvents (white spirit and related hydrocarbon solvents) for paints and other purposes |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.