BS 4480-9:1995
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Plain bearings: metric series Checking the outside diameter of wrapped bushes
Hardcopy , PDF
30-11-2007
English
15-07-1995
Important note : Users cannot be edited or removed once added to your Multi user PDF.
Committees responsible
National foreword
Specification
1. Scope
2. Normative references
3. Symbols and units
4. Outside diameter, Do
5. Purpose of checking
6. Methods of checking
7. Selection of checking method for outside diameter
8. Test ISO 3547 - A: Outside diameter, Do
9. Test ISO 3547 - B: Outside diameter, Do
10. Checking of measurement equipment with regard to
the requirements for accuracy
11. Specifications on drawings of bushes
12. Specifications for control of the checking equipment
Tables
1. Symbols and units
2. Checking loads, limiting deviations, speeds of
approach and temperatures
3. Deviations for dial gauge and electronic gauge
4. Manufacturing tolerances for the upper and lower
clamping surfaces of the measuring equipment
5. Manufacturing tolerances and wearing limits for
checking block and setting plug
6. Limiting values for the measuring equipment
A.1 Test results
B.1 Test results
Figures
1. Outside diameter of a wrapped bush
2. Typical outside diameter measuring system
3. Upper half of checking block
4. Lower half of checking block
5. Setting plug, solid, for dc,26. Setting plug, for example with bind hole,
for dc,2>80 mm
7. Ring gauge
A. (informative) Determination of uncertainty of
measurement
B. (informative) Determination of comparability
C. (informative) Bibliography
Specifies the checking of the outside diameter of wrapped bushes and describes the necessary checking methods and measuring equipment. Also gives tables, diagrams, and symbols and units.
| Committee |
MCE/12
|
| DevelopmentNote |
Reviewed and confirmed by BSI, March, 2004. (11/2004) Also numbered as ISO 12307-1 Supersedes 92/78678 DC (08/2005)
|
| DocumentType |
Standard
|
| Pages |
22
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| ISO 12301:2007 | Plain bearings — Quality control techniques and inspection of geometrical and material quality characteristics |
| ISO 12306:1994 | Plain bearings Measurement of wall thickness of thin-walled half-bearings and thin-walled bushes |
| ISO 468:1982 | Surface roughness — Parameters, their values and general rules for specifying requirements |
| ISO 286-1:2010 | Geometrical product specifications (GPS) ISO code system for tolerances on linear sizes Part 1: Basis of tolerances, deviations and fits |
| ISO 3547:1976 | Plain bearings — Wrapped bushes — Dimensions, tolerances and methods of checking |
| ISO 286-2:2010 | Geometrical product specifications (GPS) ISO code system for tolerances on linear sizes Part 2: Tables of standard tolerance classes and limit deviations for holes and shafts |
| ISO/R 1938:1971 | ISO system of limits and fits Part II : Inspection of plain workpieces |
| BS 4480-4:1979 | Specification for plain bearings: metric series Dimensions, tolerances and methods of checking wrapped bushes |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.