BS 5467:2016

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Rated voltage
5 Conductors
6 Insulation
7 Identification of cores
8 Laying-up
9 Bedding
10 Armour
11 Oversheath
12 Cable marking and additional information
13 End sealing
14 Schedule of tests
15 Test conditions
16 Routine tests
17 Sample tests
18 Type tests
Annexes
Annex A (informative) - Guide to use and installation of cables
Annex B (normative) - Armour wire tests
Annex C (normative) - Compatibility test
Annex D (normative) - Abrasion resistance test
Annex E (normative) - Insulation resistance constant
        test on oversheath
Annex F (normative) - Resistance of conductor
        and armour
Annex G (informative) - Gross cross-sectional area
        of armour
Annex H (normative) - Test for shrinkage of oversheath
        on cable
Annex I (informative) - Guidance on type tests
Annex J (informative) - United Kingdom reference
        codes
Bibliography

Describes requirements for the construction and performance of thermosetting insulated, armoured cables of rated voltages of 600/1000 V and 1900/3300 V.

This British Standard specifies requirements for the construction and performance of thermosetting insulated, armoured cables of rated voltages of 600/1000V and 1900/3300V. This British Standard is applicable to cables for use in fixed installations in industrial areas, buildings or similar applications. This British Standard specifies requirements for the following types of cables: 600/1000V cables, wire armoured and oversheathed, having single-core, two-, three-, four- and five-corestranded copper conductor; 600/1000V multicore auxiliary cables, wire armoured and oversheathed, stranded copper conductor; and 1900/3300V cables, wire armoured and oversheathed, having single-core or three-core stranded copper conductor. This British Standard is applicable to cables that are designed for a maximum sustained conductor temperature of 90°C and for a maximum short-circuit conductor temperature of 250°C (for a maximum of 5s). NOTE1 Limitation on the temperature of the cables may be imposed in situations where they might be touched or where they could touch other materials. NOTE2 AnnexA gives a guide to the use and installation of cables, AnnexB gives armour wire tests, AnnexC gives a compatibility test, AnnexD gives an abrasion resistance test, AnnexE gives an insulation resistance constant test on oversheath, AnnexF gives the resistance of conductor and armour, AnnexG gives the gross cross-sectional area of armour, AnnexH gives a test for shrinkage of oversheath on cable, AnnexI gives guidance on type tests and AnnexJ gives the standard United Kingdom reference codes.