BS 7644-2:1993
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Direct tension indicators Specification for nut face and bolt face washers
Hardcopy , PDF
31-07-2009
English
15-04-1993
Important note : Users cannot be edited or removed once added to your Multi user PDF.
Committees responsible
Foreword
Specification
1 Scope
2 Normative references
3 Dimensions
4 Characteristics
5 Marking and identification
6 Designation
Tables
1 Dimensions of nut face washers
2 Dimensions of bolt face washers
3 Characteristics
Figure
1 Dimensions of nut face or bolt face washer
List of references
Specifies the requirements for use with compressible washer in bolted structural joints.
| Committee |
FME/9
|
| DevelopmentNote |
Supersedes 90/80391 DC. (10/2005)
|
| DocumentType |
Standard
|
| Pages |
8
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy |
| BS 5950-2:2001 | STRUCTURAL USE OF STEELWORK IN BUILDING - PART 2: SPECIFICATION FOR MATERIALS, FABRICATION AND ERECTION - ROLLED AND WELDED SECTIONS |
| BS 5950-1:2000 | Structural use of steelwork in building Code of practice for design. Rolled and welded sections |
| BS 7644-1:1993 | Direct tension indicators. Specification for compressible washers |
| BS 5400-6:1999 | STEEL, CONCRETE AND COMPOSITE BRIDGES - PART 6: SPECIFICATION FOR MATERIALS AND WORKMANSHIP, STEEL |
| BS 4921:1988 | Specification for sherardized coatings on iron or steel |
| BS 4395-1:1969 | Specification for high strength friction grip bolts and associated nuts and washers for structural engineering General grade |
| BS 1706:1990 | Method for specifying electroplated coatings of zinc and cadmium on iron and steel |
| BS 7644-1:1993 | Direct tension indicators. Specification for compressible washers |
| BS 6587:1985 | Method of acceptance inspection for fasteners |
| BS 4395-2:1969 | Specification for high strength friction grip bolts and associated nuts and washers for structural engineering Higher grade bolts and nuts and general grade washers |
| BS 6322-3:1982 | Tolerances for fasteners. Specification for tolerances of washers for metric bolts, screws and nuts with thread diameters from 1 mm up to and including 150 mm. Product grades A and C |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.