BS 8610:2017

Foreword
0 Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Anchor system requirements
5 Anchor system test methods
6 Marking
7 Information to be supplied by the manufacturer
Annex A (normative) - Criteria for test laboratories
Annex B (informative) - Test rationale
Annex C (normative) - Requirements for test
        apparatus and procedures
Bibliography

Describes requirements and test methods for type testing anchor systems that are installed and tested in the base materials specified by the manufacturer for: a) restraint systems; b) fall arrest systems; c) rope access systems; d) work positioning systems; e) rescue systems; and f) evacuation systems.

This British Standard provides requirements and test methods for type testing anchor systems that are installed and tested in the base materials specified by the manufacturer for: restraint systems; fall arrest systems; rope access systems; work positioning systems; rescue systems; and evacuation systems. This British Standard covers anchor systems intended for one or more users simultaneously and specifies the maximum number of users for each type of anchor system. NOTE1 Where the manufacturer intends to rate their anchor systems for more than the specified maximum number of users, it is recommended that they liaise with an appropriate test house, taking into account the principles of this British Standard and develop a test specification accordingly. This British Standard is not applicable to: equipment conforming to BSEN516 or BSEN517; type A load-limiting anchor systems (see 3.3.2) for: rope access and work positioning; rescue – accompanied descent; rescue – remotely operated – redirect attachment; and evacuation, as they are considered not to be appropriate for such use. type C non-load-limiting and load-limiting anchor systems (see 3.3.3) for: rope access and work positioning; rescue – accompanied descent; rescue – remotely operated – redirect attachment; and evacuation, as they are considered not to be appropriate for such use. type B and type E, as described in BSEN795 , are not covered in this British Standard as they are not installed in a base material; bespoke structurally designed anchors incorporated into structures. NOTE2 The performance requirements in this British Standard are intended as minimum requirements for anchor devices, structural anchors and their base material(s). The performance requirements do not constitute structural verification of the structures for the imposed loads. This British Standard is intended for use by manufacturers, installers and users of anchor systems and also other interested parties, e.g. architects and structural engineers, including those responsible for the design of safe access and egress on structures. NOTE3 Information on the use of anchor systems in personal fall protection systems, including rope access, can be found in BS8437 , BS7985 and BS7883 . NOTE4 Anchor systems conforming to this British Standard for rope access should meet the requirements of the rope access industry for anchor systems, as detailed in BS7985 and the Industrial Rope Access Trade Association (IRATA), International code of practice for industrial rope access (ICOP) [1].