BS CECC 52000:1987

SECTION 1 - SCOPE
SECTION 2 - GENERAL
2.1 Related documents
2.2 Units, symbols and terminology
2.3 Marking
SECTION 3 - QUALITY ASSESSMENT PROCEDURE
SECTION 4 - TEST AND MEASUREMENT PROCEDURES
4.1 General
4.2 Alternative procedures
4.3 Standard conditions of testing
4.4 Visual inspection and check of dimensions
4.5 Functional tests
4.6 Remanence test
4.7 Contact circuit resistance
4.8 Voltage test
4.9 Insulation resistance
4.10 Operate, release, transfer or bridging and bounce
       times
4.11 Contact sticking
4.12 Robustness of termination
4.13 Soldering
4.14 Climatic sequence
4.15 Damp heat, steady state
4.16 Rapid change of temperature
4.17 Salt mist
4.18 Bump
4.19 Vibration
4.20 Shock
4.21 Acceleration test - Functional test only
4.22 Sealing
4.23 Electrical endurance
4.24 Maximum cycling frequency test
4.25 Mounting position test
4.26 Drain time test
SECTION 5 - ADDITIONAL PROCEDURAL REQUIREMENTS
SECTION 6 - PREFERRED VALUES
SECTION 7 - RULES FOR WRITING DETAIL SPECIFICATIONS
ANNEX A - Standard test coils

Lists test and measurement procedures for use in detail specifications and specifies the relevant quality assessment procedures and rules for writing the corresponding detail specifications. Makes extensive reference to BS CECC 19000.