BS EN 1114-3 : 2001

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 List of significant hazards
  4.1 Mechanical Hazards
  4.2 Hazards due to electrical energy
  4.3 Hazards due to hydraulic and pneumatic equipment
  4.4 Hazards due to failure of safety related parts of
      control systems
  4.5 Thermal hazards
  4.6 Hazards due to noise
  4.7 Hazards due to instability
5 Safety requirements and/or protective measures
  5.1 Mechanical hazards
      5.1.1 General
      5.1.2 Feeding zone
      5.1.3 Conveying zone
      5.1.4 Drive and power transmission zone
      5.1.5 Discharge zone
      5.1.6 Start up and machine setting operations in
            the danger zones
      5.1.7 Wheels for machinery movement for changes of
            location
      5.1.8 Falling/uncontrolled descent due to gravity
  5.2 Hazards due to electrical energy
      5.2.1 Electrical shock or burns caused by direct or
            indirect contact with live parts
      5.2.2 Hazards due to electrostatic discharge
  5.3 Hazards due to hydraulic and pneumatic equipment
  5.4 Hazards due to failure of safety related parts of
      control systems
  5.5 Thermal hazards
  5.6 Hazards due to noise
      5.6.1 Noise reduction at source by design
      5.6.2 Determination of noise emission values
      5.6.3 Declaration of noise emission values
  5.7 Hazards due to instability
6 Verification of the safety requirements and/or protective
  measures
7 Information for use
  7.1 Minimum marking on the machine
  7.2 Instruction manual
Annex ZA (informative) - Relationship between this European
         Standard and the Essential Requirements of
         EU Directive 98/37/EC
Annex ZB (informative) - Relationship between this European
         Standard and the Essential Requirements of EU
         Directive 2006/42/EC
Bibliography

Describes the safety requirements for the design and construction of haul-offs used in extrusion lines for processing plastics and rubber for the hazards identified in clause 4.