BS EN 14035-34:2003

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Construction
   4.1 Means of ignition
   4.2 Attachment of initial fuse
   4.3 Protection of initial fuse
   4.4 Materials of firework case
   4.5 Materials of ejected objects
   4.6 Integrity
   4.7 Closure of the mouth
   4.8 Net explosive content
   4.9 Vertical stability
5 Performance
   5.1 Initial fuse
   5.2 Principle effects
   5.3 Number of reports
   5.4 Burning matter
   5.5 Projected material
   5.6 Stability
   5.7 Integrity of body after functioning
6 Primary pack or selection pack
7 Minimum labelling requirements
   7.1 General
   7.2 Type name and category
   7.3 Safety information
   7.4 Name, address and telephone number of manufacturer
       or distributor or importer
   7.5 Reference to this standard
   7.6 Printing
   7.7 Marking of very small table bombs
   7.8 Additional information on the primary pack
       (if applicable)
8 Test methods
   8.1 Attachment of initial fuse (type test and batch test)
   8.2 Vertical stability test (type test)
   8.3 Performance (type test and batch test)
   8.4 Determination of net explosive content (type test)
   8.5 Side ignition of initial fuse (type test)
   8.6 Labelling (type test and batch test)
Annex A (normative) Type testing
Annex B (normative) Batch testing
Annex C (normative) Specification for test paper
Annex D (normative) Method for determination of smouldering
                    rate of cigarette

Gives requirements for the construction, performance, primary packaging and labelling of table bombs and the corresponding test methods. Applies to fireworks which are classified as table bombs in category 1 of EN 14035-2 which contain pyrotechnic composition that is nitrocellulose with a mass fraction of nitrogen of not more than 12,6%.