BS EN 14064-1:2010

Foreword
1 Scope
2 Normative references
3 Terms, definitions, symbols and abbreviations
4 Requirements
5 Test methods
6 Designation code
7 Evaluation of conformity
8 Marking and labelling
Annex A (normative) - Determination of the declared
                      values of thermal resistance
                      and thermal Conductivity
Annex B (normative) - Factory production control
Annex C (normative) - Specimen preparation method for
                      thermal resistance and thermal
                      conductivity test
Annex D (normative) - Specimen preparation method for
                      water absorption test
Annex E (normative) - Specimen preparation method for
                      airflow resistivity test
Annex F (normative) - Testing for reaction to fire
                      of products
Annex G (normative) - Testing for reaction to fire of
                      products in standardised assemblies
                      simulating end-use application(s)
Annex H (normative) - Rules for creating performance
                      charts for loose-fill insulation
                      and examples of performance charts
Annex I (normative) - Verification of performance chart
                      according to Annex H (normative)
Annex J (normative) - Specimen preparation method for
                      coverage and density measurement
Annex K (normative) - Thermal insulating products for
                      lofts - Determination of
                      settlement for blown loose fill
                      insulation
Annex L (informative) - Masonry cavity walls - Method for
                        determining suitable spacings for
                        blowing holes
Annex ZA (informative) - Clauses of this European Standard
                         addressing the provisions of the
                         EU Construction Products Directive
Bibliography

Defines the requirements for blown loose-fill mineral wool products for in-situ installation in lofts, masonry cavity walls and frame constructions.

This European Standard specifies the requirements for blown loose-fill mineral wool products for in-situ installation in lofts, masonry cavity walls and frame constructions.

This European standard is a specification for the insulation products before installation. It describes the product characteristics and includes procedures for testing, marking and labelling.

This document does not specify the required level of a given property to be achieved by a product to demonstrate fitness for purpose in a particular application. The levels required for a given application are to be found in regulations or non-conflicting standards.

NOTE To avoid water penetration in masonry walls special tests adjusted to local climate might be needed.

This document does not cover factory made mineral wool (MW) insulation products or in-situ products intended to be used for the insulation of building equipment and industrial installations.

Products with a declared thermal resistance lower than 0,25 m²·K/W or a declared thermal conductivity greater than 0,060 W/(m·K) at 10 °C are not covered by this document.

This document does not cover products intended for airborne sound insulation and for acoustic absorption applications.