BS EN 16730:2016

European foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols
5 Design approval tests and routine tests
6 Data to be supplied
7 Rules for use of sleepers and bearers with USP
8 Quality control
9 Marking, labelling and packaging
Annex A (normative) - Geometric Ballast Plate (GBP)
Annex B (normative) - USP on concrete block
Annex C (normative) - Static and low frequency dynamic
        bedding modulus of USP on concrete block or of USP
        alone with GBP
Annex D (normative) - Fatigue test of USP on concrete block
Annex E (normative) - Bond strength by pull-out of USP
        on sleeper and bearer
Annex F (normative) - Data sheet
Annex G (informative) - General design approval tests and
        the routine tests for the USP and the sleeper with USP
Annex H (informative) - Higher frequency dynamic vertical
        bedding modulus of USP on concrete block
Annex I (informative) - Fatigue test of USP on concrete
        block with GBP
Annex J (informative) - Capability of stacked storage of
        sleepers with USP
Annex K (informative) - Static and low frequency dynamic
        bedding modulus of USP on concrete sleeper or
        bearer with GBP
Annex L (informative) - Fatigue test on USP on sleeper
Annex M (informative) - Alternative fatigue test on USP on
        sleeper
Annex N (informative) - Effect of severe environmental
        conditions on USP on concrete block
Bibliography

Pertains to concrete sleepers or bearers with Under Sleeper Pads (USP) physically bonded to concrete used in ballast track and define the test procedures and their evaluation criteria.

This European Standard is applicable to concrete sleepers or bearers with Under Sleeper Pads (USP) physically bonded to concrete used in ballast track and define the test procedures and their evaluation criteria. This standard provides particular information in the following areas:

• test methods, test arrangements and evaluation criteria of Under Sleeper Pads;

• test methods, test arrangements and evaluation criteria of concrete sleepers and bearers with Under Sleeper Pads;

• data supplied by the purchaser and by the supplier;

• definition of general process of design approval tests;

• definition of routine tests.

This standard defines the specific test procedures for design approval tests, routine tests and tests concerning the determination of relevant properties of Under Sleeper Pad with or without concrete sleepers and bearers:

• fatigue tests;

• tests of capability for stacked stocking of concrete sleepers or bearers fitted with USP;

• pull-out test;

• severe environmental condition test.

This standard also sets out procedures for testing fitness for purpose and provides information on quality monitoring as part of quality assurance procedures. This standard does not, however, contain requirements pertaining to the properties of Under Sleeper Pads. It is the responsibility of the purchaser to define these requirements