BS EN 50156-1:2015

European foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 General requirements
5 Incoming supply connections and devices for
   disconnecting and emergency stop
6 Protection against electric shock
7 Environmental protection of the equipment
8 Equipotential bonding
9 Auxiliary circuits
10 Additional requirements for the application of a
   safety-related system
11 Electrical equipment
12 Cables and cords
13 Warning signs and item designation
14 Technical documentation
Annex A (informative) - Configurations of programmable
        safety devices (PSD) with reference to EN 61508
Annex B (informative) - Lifecycle of programmable safety
        device
Annex C (informative) - Management of functional safety
Annex D (informative) - Examples of determining the safety
        integrity level SIL using the risk graph method
Bibliography

Pertains to the application design and installation of electrical equipment, control circuits and safety-related systems for furnaces which are operated with solid, liquid or gaseous fuels and their ancillary equipment.

This European Standard applies to the application design and installation of electrical equipment, control circuits and safety-related systems for furnaces which are operated with solid, liquid or gaseous fuels and their ancillary equipment. It specifies requirements to meet the operating conditions of furnaces, to reduce the hazards of combustion and to protect the heated systems from damage e.g. by overheating. Such furnaces and the electrical equipment may be part by way of example of the following plant: water heating systems; steam boiler installations (steam and hot-water boilers) and heat recovery steam boilers; NOTE1 The requirements of this standard apply according to the electrical equipment of electrically heated steam boilers.

NOTE2 Seagoing vessels and offshore facilities are governed by International Maritime Law and as such are not within the scope of this standard. These requirements may be used for such facilities.

warm air heaters; hot-gas heaters; heat exchanger systems; combustion chambers of stationary turbines; as long as no other standard is applicable for combined heat and power stations, we recommend the use of the requirements of this standard; This standard may also be used as reference for electrical equipment requirements for thermoprocessing equipment. The requirements in this standard are not applicable to electrical equipment for: non-electrically heated appliances and burner control systems for household and similar purposes; furnaces using technologies for the direct conversion of heat into electrical energy; combustion chambers of non-stationary prime movers and turbines; central oil supply systems for individual heating appliances; furnaces using solid fuels for heating purposes for household use with a nominal thermal output up to 1MW; furnaces which are used to heat process fluids and gasses in chemical plant. This European Standard may be used as a basis for the requirements placed on electrical equipment for furnaces, which are excluded from its field of application.