• There are no items in your cart

BS EN 50341-2-22:2016

Superseded

Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by

Overhead electrical lines exceeding AC 1 kV National Normative Aspects (NNA) for Poland (based on EN 50341-1:2012)

Available format(s)

Hardcopy , PDF

Superseded date

30-05-2022

Superseded by

BS EN 50341-2-22:2022

Language(s)

English

Published date

30-11-2016

€327.21
Excluding VAT

European foreword
1 Scope
2 Normative references, definitions and symbols
3 Basis of design
4 Action on lines
5 Electrical requirements
6 Earthing systems
7 Supports
8 Foundations
i9 Conductors and earth-wires
10 Insulators
11 Hardware
12 Quality assurance, checks and taking-over
Annex G (normative) - Calculation methods for
        earthing systems
Annex H (informative) - Installation and measurements
        of earthing systems
Annex J (normative) - Angles in lattice steel towers
Annex K (normative) - Steel poles
Annex M (informative) - Geotechnical and structural
        design of foundations

Provides the requirements which shall be fulfilled while designing and constructing of new overhead lines with nominal system voltages exceeding 1 kV AC.

Committee
PEL/11
DevelopmentNote
Supersedes BS EN 50423-3 & BS EN 50341-3 which remains current. (11/2016)
DocumentType
Standard
Pages
74
PublisherName
British Standards Institution
Status
Superseded
SupersededBy
Supersedes

This NNA determines the requirements which shall be fulfilled while designing and constructing of new overhead lines with nominal system voltages exceeding 1 kV AC. The scope of use of this NNA for temporary lines shall be determined by the Project Specification. For modernisations, reconstructions and refurbishments of the existing lines, the scope and the requirement to comply with PN-EN-50341-1, together with this NNA, shall be determined by the Project Specification. 1.2 Field of application (ncpt) PL.1 Overhead lines with covered conductors This NNA applies to overhead lines with covered conductors and overhead insulated cable system with nominal voltage exceeding 1 kV up to 45 kV AC. Additional requirements and simplifications, which apply only to this range of voltages, have been determined. This NNA does not contain requirements applicable for designing and constructing overhead lines with nominal voltage exceeding 45 kV AC, with covered conductors, where internal and external clearances can be smaller than specified in the NNA. (ncpt) PL.2 Optical conductors/wires This NNA also applies to optical phase conductors (OPCON) and optical ground wires (OPGW), containing optical fibre telecommunication circuits, installed on overhead line supports. (ncpt) PL.3 All Dielectric Self Supporting (ADSS) cables This NNA applies to all dielectric cables (ADSS) only within the scope of their influence on the load of the support and the requirements of the insulator clearances. (ncpt) PL.4 Installation of telecommunication fittings The NNA also applies to the installation of telecommunication equipment mounted on the new line structures with their primary function as of overhead line supports.

Standards Relationship
EN 50341-2-22:2016 Identical

PN EN 10020 : 2003 DEFINITION AND CLASSIFICATION OF GRADES OF STEEL
PN EN ISO 14688-2 : 2006 AMD 1 2014 GEOTECHNICAL INVESTIGATION AND TESTING - IDENTIFICATION AND CLASSIFICATION OF SOIL - PART 2: PRINCIPLES FOR A CLASSIFICATION (ISO 14688-2:2004/AMD 1:2013)
PN EN 14229 : 2010 STRUCTURAL TIMBER - WOOD POLES FOR OVERHEAD LINES
PN EN 1991-1-4 : 2008 AMD 1 2010 EUROCODE 1: ACTIONS ON STRUCTURES - PART 1-4: GENERAL ACTIONS - WIND ACTIONS
PN EN ISO 1461 : 2011 HOT DIP GALVANIZED COATINGS ON FABRICATED IRON AND STEEL ARTICLES - SPECIFICATIONS AND TEST METHODS
PN EN 1993-1-8 : 2006 NA 2011 EUROCODE 3: DESIGN OF STEEL STRUCTURES - PART 1-8: DESIGN OF JOINTS
PN EN 1997-2 : 2009 AC 2010 EUROCODE 7 - GEOTECHNICAL DESIGN - PART 2: GROUND INVESTIGATION AND TESTING
PN E-06303 : 1998 EXPOSURE OF OUTDOOR INSULATION TO POLLUTION AND SELECTION OF INSULATORS UNDER POLLUTED CONDITIONS
PN EN 61284 : 2002 OVERHEAD LINES - REQUIREMENTS AND TESTS FOR FITTINGS
PN EN 1991-1-6 : 2007 AC 2013 EUROCODE 1 - ACTIONS ON STRUCTURES PART 1-6: GENERAL ACTIONS - ACTIONS DURING EXECUTION
PN EN 1995-1-1 : 2010 AMD 2 2014 EUROCODE 5: DESIGN OF TIMBER STRUCTURES - PART 1-1: GENERAL - COMMON RULES AND RULES FOR BUILDINGS
PN EN 1993-1-5 : 2008 AMD 1 2017 EUROCODE 3 - DESIGN OF STEEL STRUCTURES - PART 1-5: PLATED STRUCTURAL ELEMENTS
PN EN 10025-2 : 2007 HOT ROLLED PRODUCTS OF STRUCTURAL STEELS - PART 2: TECHNICAL DELIVERY CONDITIONS FOR NON-ALLOY STRUCTURAL STEELS
PN EN 1090-1 : 2010 + A1 2012 EXECUTION OF STEEL STRUCTURES AND ALUMINIUM STRUCTURES - PART 1: REQUIREMENTS FOR CONFORMITY ASSESSMENT OF STRUCTURAL COMPONENTS
PN EN ISO 14713 : 2000 PROTECTION AGAINST CORROSION OF IRON AND STEEL IN STRUCTURES - ZINC AND ALUMINIUM COATINGS - GUIDELINES
PN 80/B-03322 : 1980 ELECTRIC OVERHEAD LINES - FOUNDATIONS OF SUPPORTING STRUCTURES - STATIC CALCULATIONS AND DESIGN
PN 78/B-02483 : 1978 LARGE DIAMETER BORED PILES - SPECIFICATIONS AND TESTS
PN EN 12843 : 2008 PRECAST CONCRETE PRODUCTS - MASTS AND POLES
PN EN 1993-1-11 : 2008 NA 2010 EUROCODE 3 - DESIGN OF STEEL STRUCTURES - PART 1-11: DESIGN OF STRUCTURES WITH TENSION COMPONENTS
PN EN 1990 : 2004 NA 2010 EUROCODE - BASIS OF STRUCTURAL DESIGN
PN EN ISO 14688-1 : 2006 AMD 1 2014 GEOTECHNICAL INVESTIGATION AND TESTING - IDENTIFICATION AND CLASSIFICATION OF SOIL - PART 1: IDENTIFICATION AND DESCRIPTION (ISO 14688-1:2002/AMD 1:2013)
PN EN 1993-1-1 : 2006 AMD 1 2014 EUROCODE 3: DESIGN OF STEEL STRUCTURES - PART 1-1: GENERAL RULES AND RULES FOR BUILDINGS
PN EN 1090-2 : 2009 + A1 2012 EXECUTION OF STEEL STRUCTURES AND ALUMINIUM STRUCTURES - PART 2: TECHNICAL REQUIREMENTS FOR STEEL STRUCTURES
PN EN 1992-1-1 : 2008 AMD 1 2015 EUROCODE 2: DESIGN OF CONCRETE STRUCTURES - PART 1-1: GENERAL RULES AND RULES FOR BUILDINGS
PN EN 1997-1 : 2008 AMD 1 2014 EUROCODE 7: GEOTECHNICAL DESIGN - PART 1: GENERAL RULES
PN EN 10025-1 : 2007 HOT ROLLED PRODUCTS OF STRUCTURAL STEELS - PART 1: GENERAL TECHNICAL DELIVERY CONDITIONS
PN 83/B-02482 : 1983 BUILDING FOUNDATIONS - CAPACITY OF PILES AND PILE FOUNDATIONS
PN EN 61395 : 2002 OVERHEAD ELECTRICAL CONDUCTORS - CREEP TEST PROCEDURES FOR STRANDED CONDUCTORS
PN EN 1993-1-3 : 2008 NA 2010 EUROCODE 3 - DESIGN OF STEEL STRUCTURES - PART 1-3: GENERAL RULES - SUPPLEMENTARY RULES FOR COLD-FORMED MEMBERS AND SHEETING
PN EN 1993-3-1 : 2008 NA 2010 EUROCODE 3 - DESIGN OF STEEL STRUCTURES - PART 3-1: TOWERS, MASTS AND CHIMNEYS - TOWERS AND MASTS
PN E-05115 : 2002 POWER INSTALLATIONS EXCEEDING 1 KV A.C.
PN EN 60305 : 2007 INSULATORS FOR OVERHEAD LINES WITH A NOMINAL VOLTAGE ABOVE 1 KV - CERAMIC OR GLASS INSULATOR UNITS FOR A.C. SYSTEMS - CHARACTERISTICS OF INSULATOR UNITS OF THE CAP AND PIN TYPE
PN EN 60652 : 2006 LOADING TESTS ON OVERHEAD LINE STRUCTURES
PN EN 1998-6 : 2005 EUROCODE 8: DESIGN OF STRUCTURES FOR EARTHQUAKE RESISTANCE - PART 6: TOWERS, MASTS AND CHIMNEYS
PN EN 1993-1-6 : 2009 AMD 1 2017 EUROCODE 3 - DESIGN OF STEEL STRUCTURES - PART 1-6: STRENGTH AND STABILITY OF SHELL STRUCTURES
PN EN 61109 : 2010 INSULATORS FOR OVERHEAD LINES - COMPOSITE SUSPENSION AND TENSION INSULATORS FOR A.C. SYSTEMS WITH A NOMINAL VOLTAGE GREATER THAN 1000 V - DEFINITIONS, TEST METHODS AND ACCEPTANCE CRITERIA

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.