BS EN 60317-0-3:2008

INTRODUCTION
1 Scope
2 Normative references
3 Terms, definitions, general notes
   and appearance
4 Dimensions
5 Electrical resistance
6 Elongation
7 Springiness
8 Flexibility and adherence
9 Heat shock
10 Cut-through
11 Resistance to abrasion
12 Resistance to solvents
13 Breakdown voltage
14 Continuity of insulation (nominal conductor diameters
   up to and including 1,600 mm)
15 Temperature index
16 Resistance to refrigerants
17 Solderability
18 Heat or solvent bonding
19 Dielectric dissipation factor
20 Resistance to transformer oil
21 Loss of mass
23 Pin hole test
30 Packaging
Annex A (informative) - Dimensions for intermediate nominal
        conductor diameters (R 40)
Annex B (informative) - Method for the calculation of linear
        resistance
Annex C (informative) - Resistance
Annex ZA (normative) - Normative references to international
         Publications with their corresponding European
         publications
Bibliography

Defines the general requirements of enamelled round aluminium winding wires with or without a bonding layer.

IEC 60317-0-3:2008 gives the general requirements of enamelled round aluminium winding wires with or without a bonding layer. Technical changes from the previous edition include clarification to appearance requirements, revisions to the wire size ranges applicable to the flexibility and adherence tests, and clarification that pin hole test requirements are under consideration.