BS EN 61094-8:2012

1 Scope
2 Normative references
3 Terms and definitions
4 Reference environmental conditions
5 Principles of free-field calibration by comparison
6 General requirements
7 Factors influencing the free-field sensitivity
8 Calibration uncertainty components
Annex A (informative) - Basic substitution calibration in
        a free-field chamber
Annex B (informative) - Time selective techniques
Annex ZA (normative) - Normative references to
         international publications with their
         corresponding European publications
Bibliography

Pertains to working standard microphones meeting the requirements of IEC 61094-4.

This part of the IEC61094 series is applicable to working standard microphones meeting the requirements of IEC61094-4. It describes methods of determining the free-field sensitivity by comparison with a laboratory standard microphone or working standard microphone (where applicable) that has been calibrated according to either:

• IEC61094-3,

• IEC61094-2 or IEC61094-5, and where factors given in IEC/TS61094-7 have been applied,

• IEC61094-6,

• this part of IEC61094.

Methods performed in an acoustical environment that is a good approximation to an ideal free-field (e.g. a high quality free-field chamber), and methods that use post processing of results to minimise the effect of imperfections in the acoustical environment, to simulate free-field conditions, are both covered by this part of IEC61094. Comparison methods based on the principles described in IEC61094-3 are also possible but beyond the scope of this part of IEC61094.

NOTE 1 This part of IEC61094 is also applicable to laboratory standard microphones meeting the requirements of IEC61094-1, noting that these microphones also meet the electroacoustic specifications for working standard microphones.

NOTE 2 This part of IEC61094 is also applicable to combinations of microphone and preamplifier where the determined sensitivity is referred to the unloaded output voltage of the preamplifier.

NOTE 3 Other devices, for example, sound level meters can be calibrated using the principles of this part of IEC61094, but are not within the scope of this standard.