BS EN 61319-1:1996

Foreword
Introduction
1 Scope
2 Normative references
3 Explanation of terms and abbreviations
4 Interface requirements for polarizers and
  polarswitches
  4.1 Mechanical polarizers (optional)
  4.2 Magnetic polarizers (using the Faraday effect)
      4.2.1 Polarizers for two orthogonal polarizations
      4.2.2 Polarizers for four polarizations
  4.3 Polarswitchers
5 Interface requirements for low-noise block
  converters (LNB)
  5.1 Characteristic impedance of the first intermediate
      frequency (IF) output
  5.2 Interface between the LNB (outdoor part) and the
      satellite receiver (indoor part), case 1: one IF
      input signal and one two-state control command
      5.2.1 Single-band block converters
      5.2.2 Dual-band block converters
      5.2.3 Combination of dual-band block converter
            with polarswitcher
  5.3 Interface between the LNB (outdoor part) and the
      satellite receiver (indoor part) case 2: two IF
      input signals and internal two-state control command
  5.4 Connectors
6 Interface requirements for switching between
  different antenna sources or antenna positions
  6.1 Electrical matching values for the actuator motor
      supply
  6.2 Electrical matching values for the antenna position
      sensor
  6.3 Interface between the antenna position control unit
      and the satellite receiver
      6.3.1 Circular connector
      6.3.2 Domestic Digital Bus (D2B)
7 Interface requirements for satellite receivers and
  external decoders, descramblers and conditional
  access systems
8 Interface requirements for Digital Satellite
  Radio (DSR) receivers
  8.1 Configuration of receiving equipment
      8.1.1 Direct reception of radio only
      8.1.2 Direct reception of radio and television
      8.1.3 Cable reception
  8.2 Audio-frequency outputs of DSR receivers
Annex A (informative) Interconnections between a satellite
                       receiver and a decoder
Annex ZA (normative) Normative references to international
                       publications with their corresponding
                       European publications
Annex ZB (normative) Communication between the satellite
                       receiver and the peripheral equipment
                       using the Digital Satellite Equipment
                       Control bus (DiSEqC)
Figures

Defines the interconnections and matching values for satellite receivers for individual T.V. and sound broadcast reception in the 10,70 GHz to 12,75 GHz band.