BS EN 692 : 2005

1 Scope
2 Normative references
3 Terms, definitions and abbreviations
  3.1 Terms and definitions
  3.2 Abbreviations
4 List of significant hazards
5 Safety requirements and/or measures
  5.1 Introduction
  5.2 Basic design considerations
      5.2.1 Brakes and clutches
      5.2.2 Presses with part revolution clutches
            (friction clutches)
      5.2.3 Hydraulic and pneumatic systems -
            Common features
      5.2.4 Pneumatic systems
      5.2.5 Hydraulic systems
      5.2.6 Slide adjustment and stroke adjustment
  5.3 Mechanical hazards in the tools area
  5.4 The control and monitoring system
      5.4.1 Control and monitoring functions
      5.4.2 Part revolution clutch presses: redundancy
            and monitoring of clutch/brake control
            systems, and overrun monitoring for single
            cycle use
      5.4.3 Muting
      5.4.4 Programmable electronic systems (PES),
            programmable pneumatic systems (PPS)
            and safety related functions
      5.4.5 Selector switches
      5.4.6 Isolation switch
      5.4.7 Position switches
      5.4.8 Control devices
      5.4.9 Valves
  5.5 Tool-setting, trial strokes, maintenance and
      lubrication
  5.6 Mechanical hazards - other
  5.7 Slips, trips and falls
  5.8 Protection against other hazards
      5.8.1 Electrical hazards
      5.8.2 Thermal hazards
      5.8.3 High pressure fluid ejection hazards
      5.8.4 Hazards generated by noise
      5.8.5 Hazards generated by vibration
      5.8.6 Hazards generated by materials and
            substances
      5.8.7 Hazards generated by neglecting
            ergonomic principles
6 Verification of the safety requirements and/or measures
7 Information for use
  7.1 Marking
  7.2 Instruction handbook
Annex A (normative) - Interlocking guards
      A.1 Presses with part revolution clutches
Annex B (normative) - Calculation of minimum safety
        distances
Annex C (informative) - Electro-sensitive protective
        equipment (ESPE) using active opto-electronic
        protective devices (AOPDs)
Annex D (informative) - Closed tools
Annex E (informative) - The setting of the rotary cam
        arrangement
      E.1 Basic features of the eccentric adjustment
          and rotary cam arrangement
      E.2 Determination of the position where muting
          begins
Annex F (informative) - Determination of the overall response
        time T
Annex G (normative) - Conditions for noise measurement of
        mechanical presses
Annex ZA (informative) - Relationship between this European
         Standard and the Essential Requirements of EU
         Directive 98/37/EC, amended by Directive 98/79 EC
Annex ZB (informative) - Relationship between this European
         Standard and the Essential Requirements of EU
         Directive 2006/42/EC
Bibliography

Describes technical safety requirements and measures to be adopted by persons undertaking the design, manufacture and supply of mechanical presses with part revolution clutch hereinafter called presses which are intended to work cold metal or material partly of cold metal.