BS EN ISO 9445-2:2010

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Information to be supplied by the purchaser
5 Type of delivery and delivery condition
6 Preferred thicknesses
7 Tolerances on thickness for cold-rolled wide strip
   and products obtained from cold-rolled wide strip
8 Tolerances on width for cold-rolled wide strip and
   products obtained from cold-rolled wide strip
9 Preferred coil inner diameters for cold-rolled wide
   strip and slit cold-rolled wide strip
10 Tolerances on length for plate/sheet cut from
   cold-rolled wide strip and for cut lengths obtained
   from slit cold-rolled wide strip
11 Tolerances on edge camber for cold-rolled wide strip
   and products obtained from cold-rolled wide strip
12 Tolerances on squareness for plate/sheet obtained from
   cold-rolled wide strip and cut lengths obtained from
   slit cold-rolled wide strip
13 Tolerances on flatness for plate/sheet obtained
   from cold-rolled wide strip and cut lengths obtained
   from slit cold-rolled wide strip
14 Edge waviness tolerances for cold-rolled strip
15 Form of coils
16 Ordered format for plate/sheet and cut lengths
17 Measurement of thickness for cold-rolled wide strip,
   plate/sheet cut from cold-rolled wide strip, slit
   cold-rolled wide strip and cut lengths obtained from
   slit cold-rolled wide strip
18 Measurement of width
19 Measurement of length
20 Measurement of edge camber
21 Measurement of squareness
22 Measurement of flatness and waviness

Describes the tolerances on dimensions and form for continuously cold-rolled stainless steel wide strip and plate/sheet, in thicknesses from 0,30 mm to 8,0 mm and in rolling widths from 600 mm to 2100 mm.

This part of ISO9445 specifies the tolerances on dimensions and form for continuously cold-rolled stainless steel wide strip and plate/sheet, in thicknesses from 0,30mm to 8,0mm and in rolling widths from 600mm to 2100mm. It also applies to slit cold-rolled wide strip in widths less than 600mm manufactured from wide strip by longitudinal slitting and to cut lengths manufactured from such strip.