EN ISO 9445-2:2010

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Information to be supplied by the purchaser
5 Type of delivery and delivery condition
6 Preferred thicknesses
7 Tolerances on thickness for cold-rolled wide strip and
   products obtained from cold-rolled wide strip
8 Tolerances on width for cold-rolled wide strip and
   products obtained from cold-rolled wide strip
9 Preferred coil inner diameters for cold-rolled wide strip
   and slit cold-rolled wide strip
10 Tolerances on length for plate/sheet cut from cold-rolled
   wide strip and for cut lengths obtained from slit
   cold-rolled wide strip
11 Tolerances on edge camber for cold-rolled wide strip and
   products obtained from cold-rolled wide strip
12 Tolerances on squareness for plate/sheet obtained from
   cold-rolled wide strip and cut lengths obtained from slit
   cold-rolled wide strip
13 Tolerances on flatness for plate/sheet obtained from
   cold-rolled wide strip and cut lengths obtained from slit
   cold-rolled wide strip
14 Edge waviness tolerances for cold-rolled strip
15 Form of coils
16 Ordered format for plate/sheet and cut lengths
17 Measurement of thickness for cold-rolled wide strip,
   plate/sheet cut from cold-rolled wide strip, slit
   cold-rolled wide strip and cut lengths obtained from slit
   cold-rolled wide strip
18 Measurement of width
19 Measurement of length
20 Measurement of edge camber
21 Measurement of squareness
22 Measurement of flatness and waviness

ISO 9445-2:2009 specifies the tolerances on dimensions and form for continuously cold-rolled stainless steel wide strip and plate/sheet, in thicknesses from 0,30 mm to 8,0 mm and in rolling widths from 600 mm to 2 100 mm. It also applies to slit cold-rolled wide strip in widths less than 600 mm manufactured from wide strip by longitudinal slitting and to cut lengths manufactured from such strip.