BS IEC 62873-3-2:2016

FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 Classification
5 Characteristics of RCDs
6 Marking and other product information
7 Standard conditions for operation in service
  and for installation
8 Requirements for construction and operation
9 Tests
Bibliography

Pertains to RCDs equipped with flat quick-connect terminations consisting of a male tab with nominal width 6,3 mm and thickness 0,8 mm, to be used with a mating female connector for connecting electrical copper conductors according to the manufacturer's instructions, for rated currents up to and including 16 A.

This part of IEC 62873 applies to RCDs equipped with flat quick-connect terminations consisting of a male tab (see 3.2) with nominal width 6,3 mm and thickness 0,8 mm, to be used with a mating female connector for connecting electrical copper conductors according to the manufacturer\'s instructions, for rated currents up to and including 16 A.

NOTE The use of RCDS with flat quick-connect terminations for rated currents up to and including 20 A is accepted in BE, FR, IT, ES, PT and US.

This part of IEC 62873 cannot be used alone but is intended to be applied together with an RCD product standard (IEC 61008-1 or IEC 61009-1) if an RCD is equipped with flat quick-connect terminations.

The connectable electrical copper conductors are flexible, having a cross-sectional area up to and including 4 mm2, or rigid stranded, having a cross-sectional area up to and including 2,5 mm2 (AWG equal to or greater than 12).

This part of IEC 62873 applies exclusively to RCDs having male tabs as an integral part of the device.