BS ISO 14743:2004
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Pneumatic fluid power. Push-in connectors for thermoplastic tubes
Hardcopy , PDF
23-09-2023
English
08-12-2004
Important note : Users cannot be edited or removed once added to your Multi user PDF.
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Performance requirements
4.1 Material
4.2 Pressure and temperature
5 Features
6 Outside diameter of tube
7 Design
8 Marking
9 Performance requirements and testing
9.1 General
9.2 Test samples
9.3 Tensile test
9.4 Proof and burst pressure test (for polyamide tubing
only)
9.5 Connecting force test
9.6 Disconnecting force test
9.7 Leakage test (to be performed before disconnecting)
9.8 Cyclic endurance (impulse) test with vibration (for
polyamide tubing only)
10 Designation
11 Identification statement (reference to this International
Standard)
Annex A (normative) Polyamide tubes for testing
Annex B (normative) Polyurethane tubes for testing
Bibliography
Specifies the general requirements and test methods for the design and performance of push-in connectors for use with thermoplastic tubes with outside diameters of 3 mm to 12 mm, inclusive.
| Committee |
MCE/18
|
| DevelopmentNote |
Supersedes 97/712903 DC. (12/2004)
|
| DocumentType |
Standard
|
| Pages |
32
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| Standards | Relationship |
| ISO 14743:2004 | Identical |
| ISO 5598:2008 | Fluid power systems and components Vocabulary |
| ISO 4759-1:2000 | Tolerances for fasteners — Part 1: Bolts, screws, studs and nuts — Product grades A, B and C |
| ISO 4397:2011 | Fluid power connectors and associated components — Nominal outside diameters of tubes and nominal hose sizes |
| ISO 6358:1989 | Pneumatic fluid power Components using compressible fluids Determination of flow-rate characteristics |
| ISO 8573-1:2010 | Compressed air Part 1: Contaminants and purity classes |
| ISO 16030:2001 | Pneumatic fluid power — Connections — Ports and stud ends |
| ISO 228-1:2000 | Pipe threads where pressure-tight joints are not made on the threads Part 1: Dimensions, tolerances and designation |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.