BS ISO 3739-1:2007
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Industrial tyres and rims Pneumatic tyres (metric series) on 5° tapered on flat base rims. Designation, dimensions and marking
Hardcopy , PDF
English
31-07-2007
28-10-2022
| Committee |
AUE/4
|
| DevelopmentNote |
Supersedes BS AU50-1.5.2(1994). (07/2007)
|
| DocumentType |
Standard
|
| Pages |
20
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
This part of ISO3739 specifies the main requirements of the metric series of pneumatic tyres primarily intended for industrial vehicles, including designations, dimensions and markings. The tyres are based on the following parameters:
-
speeds not exceeding 50km/h;
-
use on 5° tapered or flat base rims.
The conversion of code-designated industrial tyres into metric-designated tyres is outside the scope of this part of ISO3739.
| Standards | Relationship |
| ISO 3739-1:2007 | Identical |
| ISO 31-0:1992 | Quantities and units — Part 0: General principles |
| ISO 3877-1:1997 | Tyres, valves and tubes — List of equivalent terms — Part 1: Tyres |
| ISO 4223-1:2002 | Definitions of some terms used in the tyre industry — Part 1: Pneumatic tyres |
| ISO 3739-2:1992 | Industrial tyres and rims — Part 2: Pneumatic tyres (metric series) on 5 degrees tapered or flat base rims — Load ratings |
| ISO 3739-3:2008 | Industrial tyres and rims — Part 3: Rims |
Access your standards online with a subscription
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.
Important note : Users cannot be edited or removed once added to your Multi user PDF.