BS ISO 7206-12:2016
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Implants for surgery. Partial and total hip joint prostheses Deformation test method for acetabular shells
Hardcopy , PDF
English
30-09-2016
25-11-2025
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Principle
5 Apparatus
6 Procedure
7 Report
Bibliography
Defines a test method for determining short-term deformation of a press-fit acetabular component for total hip joint replacement under specific laboratory conditions.
| Committee |
CH/150/4
|
| DevelopmentNote |
Supersedes 15/30296038 DC. (10/2016)
|
| DocumentType |
Standard
|
| Pages |
20
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
This part of ISO7206 specifies a test method for determining short-term deformation of a press-fit acetabular component for total hip joint replacement under specific laboratory conditions. It also defines the conditions of testing so that the important parameters that affect the components are taken into account and it describes how the specimen is set up for testing. Furthermore, this part of ISO7206 specifies the test parameters of press-fit acetabular components tested in accordance with this part of ISO7206.
The described method is intended to be used to evaluate the comparison of various designs and materials used for acetabular components in total hip joint replacement when tested under similar conditions.
The loading of the acetabular components in vivo will, in general, differ from the loading defined in this test method. The results obtained here cannot be used to directly predict in vivo performance.
This part of ISO7206 does not cover methods of examining the test specimen.
| Standards | Relationship |
| ISO 7206-12:2016 | Identical |
| ISO 21534:2007 | Non-active surgical implants — Joint replacement implants — Particular requirements |
| ISO 2768-2:1989 | GENERAL TOLERANCES - PART 2: GEOMETRICAL TOLERANCES FOR FEATURES WITHOUT INDIVIDUAL TOLERANCE INDICATIONS |
| ISO 7206-2:2011 | Implants for surgery — Partial and total hip joint prostheses — Part 2: Articulating surfaces made of metallic, ceramic and plastics materials |
| ISO 7206-1:2008 | Implants for surgery — Partial and total hip joint prostheses — Part 1: Classification and designation of dimensions |
Access your standards online with a subscription
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.
Important note : Users cannot be edited or removed once added to your Multi user PDF.