BS ISO 7241-2:2000

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Selection and examination of test samples
5 Test apparatus
6 Test conditions
7 Connect force test
8 Disconnect force test
9 Leakage test
      9.1 Low pressure, coupled
      9.2 Low pressure, uncoupled (valved only)
      9.3 Maximum operating pressure, coupled
      9.4 Maximum operating pressure, uncoupled (valved
             only)
10 Extreme temperature test
      10.1 Maximum operating temperature exposure,
             coupled
      10.2 Maximum operating temperature exposure,
             uncoupled (valved only)
      10.3 Maximum operating temperature service, coupled
      10.4 Maximum operating temperature service,
             uncoupled (valved only)
      10.5 Minimum operating temperature, coupled
      10.6 Minimum operating temperature, uncoupled
             (valved only)
11 Pressure impulse test
      11.1 Test coupling
      11.2 Coupled test
      11.3 Uncoupled test (valved only)
12 Rotating impulse test
13 Endurance test
14 Pressure drop test
15 Vacuum test
      15.1 Coupled test
      15.2 Uncoupled test (valved only)
16 Air inclusion test
17 Spillage test
18 Static pressure test
      18.1 Coupled
      18.2 Uncoupled (valved type only)
19 Surge flow test - long duration
20 Surge flow test - short duration
21 Burst test
      21.1 Safety precautions
      21.2 Burst pressure, uncoupled (valved type only)
      21.3 Burst pressure, coupled
22 Data accuracy
23 Test report and data presentation
24 Summary of information to be supplied
25 Test/production similarity
26 Identification statement (Reference to this part of
      ISO 7241)
Annex A (normative) Test data form

Defines differing test procedures that could be applied to quick-action couplings. Applies to male and female coupling halves, complete couplings, couplings with or without sealing means when uncoupled, and couplings that are connected and disconnected by a rotational and/or linear motion.